Results 11 to 20 of about 246,573 (299)
Nanomaterials, 2022 Fluorescent antifouling and photocatalytic antifouling technologies have shown potential in the field of marine antifouling. SLAP@g-C3N4/PDMS (SLAP@CN/PDMS) composite antifouling coatings were designed and prepared using g-C3N4, sky-blue long afterglow ...
Gang Xiong +3 more
doaj +1 more source
Effects of modified SWCNT on the mechanical and thermal properties of PLA/PHB bio-composites
AIP Advances, 2020 Humic acid (HA) was first loaded on single-walled carbon nanotubes (SWCNTs) and then the HA-loaded SWCNTs (FSWCNTs) were further incorporated into polylactic acid/poly-β-hydroxybutyrate (PLA/PHB) composites (with a weight ratio of 60/40) to synthesize ...
A. Ruoling Liu +6 more
doaj +1 more source
Complication of Augmentation Mammoplasty using Polysaccharide Hydrogel Breast implant: Two Cases Report [PDF]
Archives of Aesthetic Plastic Surgery, 2013 After the use of silicone-filled breast implant was restricted in 1992, PIP Hydrogel (Poly Implant Prosthesis, France) was temporarily used as an alternative which is an organic polymer of polysaccharide and water.
Young Taek Lee +3 more
doaj +1 more source
Lysine-Based Silicone Surfactants
Sustainable Chemistry, 2023 Highly efficient silicone surfactants are typically based on polyether hydrophiles. As part of a program to increase the natural content of silicones, we describe the synthesis of silicone surfactants with amino acid hydrophiles (cysteine, arginine, and ...
Abygail Camacho Ramirez +3 more
doaj +1 more source
Chairside Pickup of Hader Attachment Sleeves using Condensation Silicone Putty and Pattern Resin- A Novel and Precise Technique [PDF]
Journal of Clinical and Diagnostic Research, 2019 This article describes an easy, economic and precise method for chairside pickup of Hader bar sleeves using condensation silicone putty and pattern resin. After torquing the titanium bar, proper block out is carried out using condensation silicone putty,
BC Muddugangadhar +3 more
doaj +1 more source
Mechanical properties of bulk Sylgard 184 and its extension with silicone oil
Scientific Reports, 2021 Due to its simple curing and very good mechanical properties, Sylgard 184 belongs to the most widely and frequently used silicones in many industrial applications such as microfluidics and microengineering.
R. Moučka +3 more
semanticscholar +1 more source
Nanomaterials, 2019 The thermally conductive properties of silicone thermal grease enhanced by hexagonal boron nitride (hBN) nanosheets as a filler are relevant to the field of lightweight polymer-based thermal interface materials.
Weijie Liang +9 more
doaj +1 more source
Innovative Surgical Sciences, 2022 Autologous transplants are still the means of choice for bypass surgery. In addition to good tolerability, there is a reduced thrombogenicity and fewer neointima hyperplasia compared to artificial materials. However, since viable transplants are limited,
Tilkorn Daniel J. +5 more
doaj +1 more source
, 2020 Ternary heterogeneous MWCNT@TiO2-C wave absorbent was firstly prepared, using glucose, MWCNT, and titanium isopropoxide as raw materials, through the solvothermal process followed by post-heat treatment.
Jia Zhao +8 more
semanticscholar +1 more source
On the stress recovery behaviour of Ecoflex silicone rubbers
, 2021 Silicone rubbers are promising materials that have extensively been used in many areas, including wearable electronic devices, actuator materials in soft robotics, and energy harvesters.
Zisheng Liao +5 more
semanticscholar +1 more source