Results 31 to 40 of about 443,736 (233)
The Decrease of the Strength of Unsaturated Silty Sand [PDF]
It is generally considered that the shear strength of fine soils continuously increases with suction; however, this is not the case for all types of soils. There are some soils whose strength reaches a maximum at certain suction and then reduces with further of suction. Nevertheless, such cases have not been completely documented and analyzed.
Julio César Leal-Vaca +2 more
openaire +1 more source
Effect of Reinforcement on Properties of Silty Sand
Abstract: The variation of the stress-strain behavior and shear -parameters of reinforced silty sand is studied. The geotextiles were provided at different heights in the sample and tested in unconsolidated undrained condition. Two types of geotextiles, woven and nonwoven were used as reinforcement and the experiment was conducted at three water ...
openaire +1 more source
Effect of Relative Density and Stress Level on the Bearing Capacity of Footings on Sand [PDF]
The design of shallow foundations relies on bearing capacity values calculated using empirical procedures that are based in part on solutions obtained using the method of characteristics, which assumes a soil that is perfectly plastic following an ...
Loukidis, D, Salgado, Rodrigo
core +1 more source
Benefiting from low cost, high tensile strength, chemical stability, and great resistance to temperature, alkaline, and acids, it is a reasonable and valuable technology to use basalt fiber (BF) as an admixture to optimize building materials. So far, the
Shuang Sun +4 more
doaj +1 more source
Experimental study on mechanism for pumping-induced land subsidence [PDF]
Groundwater pumping can cause severe land subsidence, yet the mechanisms have not been completely clear. A laboratory physical model test was done to investigate the mechanism for pumping-induced land subsidence.
Y. Zhang +5 more
doaj +1 more source
Adsorption desorption is an important behavior affecting the migration of phenanthrene in soil. In this study, three typical soils of loess, silts and silty sand in Guanzhong Basin, Shaanxi Province, China were used as adsorbents.
Hua Tian +5 more
doaj +1 more source
Data‐Driven Bulldozer Blade Control for Autonomous Terrain Leveling
A simulation‐driven framework for autonomous bulldozer leveling is presented, combining high‐fidelity terramechanics simulation with a neural‐network‐based reduced‐order model. Gradient‐based optimization enables efficient, low‐level blade control that balances leveling quality and operation time.
Harry Zhang +5 more
wiley +1 more source
Silty Sand Stabilized with Different Binders
AbstractThe paper presents results of unconfined compression strength and seismic wave measurements during curing on a silty sand stabilized with three type of binders: geopolymers, lime and a mixture of lime and fly ash. Unconfined compression tests and indirect tensile tests were performed after 63 days of curing, and seismic wave measurements with ...
Rios, Sara +2 more
openaire +3 more sources
MOF‐Derived Cu‐TiO2/Alginate Micromotors for Buoyancy‐Regulated 3D Motion
In this work, cyanobacteria‐inspired sodium alginate (SA)/Cu‐TiO2/Fe3O4 hydrogel micromotors generate and encapsulate O2 microvesicles upon light irradiation, enabling buoyancy‐mediated Z‐axis upward migration and surface enrichment at the light‐exposed water‐air surface.
Wei Zou +7 more
wiley +1 more source
Sand production is a crucial geotechnical issue for safe and efficient gas recovery from natural gas hydrate (NGH) reservoirs. Although the same gas production method of depressurization was chosen for the production trials in the Nankai Trough and the ...
Fulong Ning +9 more
doaj +1 more source

