Results 171 to 180 of about 553,642 (323)

Direct Consolidation of Copper–Graphene Composite by Rotary Swaging

open access: yesAdvanced Engineering Materials, EarlyView.
The applicability of the rotary swaging method for preparation of electroconductive copper–graphene composite by direct consolidation of powders is proven. The consolidated material features advantageous microstructure featuring fine grains and twins, with homogeneous distribution of graphene, primarily along the twin boundaries, which contribute to ...
Radim Kocich   +2 more
wiley   +1 more source

Geometry‐Based Scan Curve Analysis: Rapid Method for the Evaluation of Scan Strategies in Powder Bed Fusion

open access: yesAdvanced Engineering Materials, EarlyView.
This study presents rapid evaluation methods for scan strategies in powder bed fusion (PBF) of polymers with a NIR laser as an example for its application. It uses line buffer‐based calculations and point density fields to predict the performance of four different scan strategies. The methods show promising results in laser‐based PBF of polymer samples,
Simon Leupold   +9 more
wiley   +1 more source

Comparison between biliary plastic stents with and without application of silver nanoparticles: an in-vitro study of the biofilm formation. [PDF]

open access: yesActa Cir Bras
Flumignan VK   +10 more
europepmc   +1 more source

Microstructure, Mechanical Properties, and Antibacterial Performance of Novel Fe‐Mn‐Zn Nanocrystalline Alloys Produced by Mechanical Alloying

open access: yesAdvanced Engineering Materials, EarlyView.
This article presents the development of Fe‐Mn‐Zn nanocrystalline alloys (0–9 wt% Zn) by mechanical alloying and subsequently hot pressing. Their microstructure, density, hardness, wear resistance, corrosion behavior, and antibacterial properties are systematically examined.
Ilker Emin Dag   +3 more
wiley   +1 more source

Fractographic Analysis and Fatigue Behavior of Additively Manufactured Ni‐Superalloy Components with Post Processing Heat Treatment and Hot Isostatic Pressing

open access: yesAdvanced Engineering Materials, EarlyView.
A study of mechanical properties and fractography of PBF‐LB/M‐built Inconel 718, performing heat treatments and hot‐isostatic pressing, is presented. Ultimate tensile strength and fatigue behavior are evaluated, examining differences in maximum load behavior, elongation, and regimes of fatigue.
David Sommer   +3 more
wiley   +1 more source

Enhanced Mechanical Properties of Injectable Chitosan–Guar Gum Hydrogel Reinforced with Bacterial Cellulose Nanofibers for Tissue Engineering Applications

open access: yesAdvanced Engineering Materials, EarlyView.
This study presents the development and characterization of injectable nanocomposite hydrogels based on N‐succinyl chitosan, oxidized guar gum, and bacterial cellulose nanofibers. Emphasizing enhanced mechanical properties and biocompatibility, the hydrogels exhibit fast gelation, improved structural integrity, and reduced swelling. Their potential for
Raimundo Nonato Fernandes Moreira Filho   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy