Results 201 to 210 of about 103,109 (304)

Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition

Advanced Engineering Materials, EarlyView.
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley   +1 more source

Quadratic Motion Polynomials with Irregular Factorizations. [PDF]

Adv Appl Clifford Algebr
Thimm DA, Li Z, Schröcker HP, Siegele J.   +3 more
europepmc   +1 more source

Air‐Pressure–Actuated Vibroacoustic Metamaterial With Tunable Bandgap: Design, Modeling, and Characterization

Advanced Engineering Materials, EarlyView.
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal, Michael M. Becker, Sarah C. L. Fischer   +2 more
wiley   +1 more source

On the Open TS/ST Correspondence. [PDF]

Commun Math Phys
François M, Grassi A.
europepmc   +1 more source

Panel Unit Root Tests in the Presence of Cross-Sectional Dependencies: Comparison and Implications for Modelling

Several panel unit root tests that account for cross section dependence using a common factor structure have been proposed in the literature recently, notably Pesaran (2003), Moon and Perron (2004) and Bai and Ng (2004).
Urbain,Jean-Pierre, Palm,Franz, Gengenbach,Christian   +2 more
core  

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

Advanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi, Hiroyuki Awano, Kenji Tanabe   +2 more
wiley   +1 more source

Divergent Phosphorus-Mining Strategies in Simple and Compound Cluster Roots in Extremely Phosphorus-Impoverished Soils in Southwest Australia. [PDF]

Plant Cell Environ
Yamada H, Gille CE, Pallavi, Yan L, Nealon G, Wasaki J, Veneklaas EJ, Lambers H.   +7 more
europepmc   +1 more source

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics

Advanced Engineering Materials, EarlyView.
Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost, Lionel Presmanes, Soléna Colin, Marie Vidal, Sophie Guillemet‐Fritsch   +4 more
wiley   +1 more source

Non-destructive monitoring of root biomass in hydroponically grown leafy vegetables: comparison between machine learning-based RGB and hyperspectral imaging. [PDF]

Plant Methods
Jin Z, Yasutake D, Iwao T, Sago Y, Yokoyama G, Kubota S, Hirota T.   +6 more
europepmc   +1 more source