Results 271 to 280 of about 421,397 (304)
Some of the next articles are maybe not open access.
SPIE Proceedings, 2008
Dielectric electroactive polymer membranes have been shown to have capabilities both as actuators and generators. Recent models of actuators have shown input to output dynamics that link the electrical energy input to the acceleration of a mass. Models such as these are useful for implementing closed loop control systems and will be necessary in the
Ihlefeld, Curtis M., Qu, Zhihua
openaire +2 more sources
Dielectric electroactive polymer membranes have been shown to have capabilities both as actuators and generators. Recent models of actuators have shown input to output dynamics that link the electrical energy input to the acceleration of a mass. Models such as these are useful for implementing closed loop control systems and will be necessary in the
Ihlefeld, Curtis M., Qu, Zhihua
openaire +2 more sources
Modeling and Simulation Approach to Design of Identification Experiment
IFAC Proceedings Volumes, 2000Abstract A popular method of identification experiment design is based on Fisher information matrix and Rao-Cramer inequality giving a lower bound on error covariance matrix in a case of unbiased identification. This result relies on data only apart from technical realization of signal acquisition and implementation of identification algorithm, so it
openaire +1 more source
Model Identification and Controller Simulation for Distillation Column
2022 International Conference on Inventive Computation Technologies (ICICT), 2022Sandeep Kumar Sunori +6 more
openaire +1 more source
Europec/EAGE Conference and Exhibition, 2008
Abstract Hassi Messaoud field heterogeneous and tight reservoir modeling has for decades been a challenge. While the matrix contains most of the fluid and the fractures contribute most to the fluid flow, conductivity is the result a complex network of fissures and fractures.
Salim Bachiri +2 more
openaire +1 more source
Abstract Hassi Messaoud field heterogeneous and tight reservoir modeling has for decades been a challenge. While the matrix contains most of the fluid and the fractures contribute most to the fluid flow, conductivity is the result a complex network of fissures and fractures.
Salim Bachiri +2 more
openaire +1 more source
Simulation models applicable to HVAC components; parameter identification and system simulation
2006A few examples of HVAC component modeling are presented in this paper. Some information is also given about the way to tune and to validate these models. Main “traps” are indicated. The three components are an air-cooled chiller, a cooling coil and a condensing boiler.
Lebrun, Jean +2 more
openaire +1 more source
Modeling, Identification and Simulation of Dynamical Systems
2020Bosch, van den, P.P.J. +1 more
openaire +2 more sources
Identification and Simulation of Elastic-Plastic Deformation Model
Materials Science Forum, 2005Łukasz Maciejewski +2 more
openaire +1 more source
Integrative oncology: Addressing the global challenges of cancer prevention and treatment
Ca-A Cancer Journal for Clinicians, 2022Jun J Mao,, Msce +2 more
exaly
Target Identification and Validation Using Human Simulation Models
2006Alex Bangs +2 more
openaire +2 more sources
UAV Modeling, Simulation, Estimation, and Identification: Introduction
2014Kimon P. Valavanis +1 more
openaire +1 more source