Results 151 to 160 of about 515,069 (282)
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi +7 more
wiley +1 more source
Online Optimizing Control and Dynamic Operation and Design Optimization of a Batch Electrodialysis Process for Sulfuric Acid Recovery. [PDF]
Latinis A, Papadopoulos AI, Seferlis P.
europepmc +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Evolutions of partner-ruled surfaces with simultaneous inextensibility conditions. [PDF]
Eren K, Ersoy S, Khan MNI.
europepmc +1 more source
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Quenching Single-Fluorophore Systems and the Emergence of Nonlinear Stern-Volmer Plots. [PDF]
Zangi R.
europepmc +1 more source
Minimum Second Moment Estimation in Simultaneous Equation Systems
Nagar, A. L., Carter, R. A. L.
openaire +3 more sources
The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
Green RP-HPLC method for the simultaneous determination of octenidine and phenoxyethanol in antiseptic formulations: integration of a lean six sigma approach. [PDF]
Salah El-Din SH +3 more
europepmc +1 more source
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source

