Results 11 to 20 of about 858,505 (337)
Results in EngineeringThe power transformer is a critical device in power systems. This paper addresses one of the major problems which hopes to enhance the accuracy of estimation of parameters, which is critical in power transformer modeling, maintenance, and operating ...
Amlak Abaza +4 more
doaj +3 more sources
Results in EngineeringThis research addresses, from a perspective of metaheuristic optimization, the problem regarding parametric estimation in single-phase transformers while considering voltage and current measures at the terminals of the transformer and weighing linear ...
Juan David Camelo-Daza +3 more
doaj +3 more sources
Experimental simulation analysis for single phase transformer tests
Bulletin of Electrical Engineering and Informatics, 2020 Transformer is one of main components in electrical power system which role to increase or reduce voltage. Characteristics of transformer would be vital to ensure the voltage is fully transferred. A single-phase transformer is a type of power transformer that utilizes single-phase alternating current, meaning the transformer relies on a voltage cycle ...
Ali Hamoodi +2 more
openaire +3 more sources
IEEE transactions on magnetics, 2019 The solid-state transformer (SST) is an emerging technology which is gaining increasing importance for future power distribution systems. Here, we present 2-D finite-element analysis (FEA) of single-phase SSTs for operating frequencies of 50 kHz.
M. Nazmunnahar +4 more
semanticscholar +1 more source
Characterization of Few Mode Fibers by OLCI Technique [PDF]
, 2014 International audienceAll LP modes of a few mode fiber are simultaneously characterized using phase-sensitive optical low-coherence interferometry. The differential modal group delay and absolute chromatic dispersion values of each mode are retrieved ...
Gabet, R. +7 more
core +3 more sources
International Journal of Electrical Power & Energy Systems, 2019 The transformer model is very important for the transient simulations of power systems. Although a large number of researches have been carried out on the developments and applications of the transformer model, there are still some deficiencies in the ...
W. Sima +6 more
semanticscholar +1 more source
IEEE Transactions on Smart Grid, 2021 Turn-to-turn faults between primary windings due to insulation degradation are a major cause of distribution transformer failure, and occur due to high levels of stress such as overloading and overheating.
Kavya Ashok +3 more
semanticscholar +1 more source
Optimal passive filter design for effective utilization of cables and transformers under non-sinusoidal conditions [PDF]
, 2014 Transformers and cables have overheating and reduced loading capabilities under non-sinusoidal conditions due to the fact that their losses increases with not only rms value but also frequency of the load current.
Aleem, SHEA +3 more
core +1 more source
Research on the Magnetostrictive Characteristics of Transformers under DC Bias
Energies, 2023 Direct current (DC) bias leads to increased vibration and noise in transformers. One of the main causes is the magnetostrictive effect of the transformer core.
Xiaoli Yan +4 more
doaj +1 more source
A Solid State Transformer model for power flow calculations [PDF]
, 2017 This paper presents the implementation of a Solid State Transformer (SST) model in OpenDSS. The goal is to develop a SST model that could be useful for assessing the impact that the replacement of the conventional iron-and-copper transformer with the SST
Guerra Sánchez, Luis Gerardo +1 more
core +2 more sources