Results 141 to 150 of about 263,020 (218)

Response law and limit of triple bore pressure relief in coal seams under mining induced load. [PDF]

Sci Rep
Lixin Z, Zehui D, Gang L, Guangchao L, Xu L.   +4 more
europepmc   +1 more source

Characterization of Hexagonal Close-Packed Zn-Cu-Ti Alloy Pyramid Drawpieces in Single-Point Incremental Sheet Forming Process. [PDF]

Materials (Basel)
Kuczek Ł, Żaba K, Trzepieciński T, Balcerzak M, Novák V.   +4 more
europepmc   +1 more source

Geographic access to radiotherapy facilities in Japan. [PDF]

J Radiat Res
Koike Y, Nakamura S, Numasaki H, Tanigawa N.   +3 more
europepmc   +1 more source

Mass hepatitis C virus screening among persons in custody in Hong Kong: a modelling cost-effectiveness analysis based on a prospective cohort study. [PDF]

Lancet Reg Health West Pac
Dai Z, Wong KT, Chow E, Seto WK, Yuen MF, Li X, Mak LY.   +6 more
europepmc   +1 more source

A Review: Absolute Linear Encoder Measurement Technology. [PDF]

Sensors (Basel)
Zhao M, Yuan Y, Luo L, Li X.
europepmc   +1 more source

State of the Art in Incremental Forming: Process Variants, Tooling, Industrial Applications for Complex Part Manufacturing and Sustainability of the Process. [PDF]

Materials (Basel)
Popp GP, Racz SG, Breaz RE, Oleksik VȘ, Popp MO, Morar DE, Chicea AL, Popp IO.   +7 more
europepmc   +1 more source

Comparative cost-effectiveness of cross-sectional imaging strategies in the diagnosis of intervertebral disc extrusion in dogs: a United Kingdom-based decision-analytic study. [PDF]

J Vet Intern Med
Low D.
europepmc   +1 more source

Model predictive control with adaptive Kalman filter for premixed turbocharged natural gas engine. [PDF]

Sci Rep
Xiong W, Gong Q, Huang S, Ye J, Xu J.
europepmc   +1 more source

Numerical Simulation Study on Non-Axisymmetric Die-Less Spinning with a Right-Angle Groove in the Tube. [PDF]

Materials (Basel)
Ren X, Fan Z, Jia Z, Shen Y, You H.
europepmc   +1 more source

Multi-layer and multi-channel deposition defects and inter-layer control strategies in additive manufacturing materials. [PDF]

PLoS One
Sun W, Li M.
europepmc   +1 more source