Results 21 to 30 of about 477,096 (342)
Trade-off study of heat sink and output filter volume in a GaN HEMT based single phase inverter [PDF]
, 2017 This paper presents the trade-off study of heat sink and output filter volume of a GaN HEMT based single phase inverter. The selected topology is three-level Active Neutral point Clamped (ANPC) inverter, and the main aim is to explore the benefits of the
Castellazzi, Alberto, Gurpinar, Emre
core +2 more sources
An Efficient Grid-tied Flyback Micro-inverter with DCM Control Strategy
Journal of Techniques, 2021 In two-stage micro-inverter photovoltaic (PV) applications, DC/DC converter is used to obtain the highest DC power from the PV module. In this type of inverter, the rising of voltage from the PV module to a grid voltage level is limited to a certain ...
Salam Jabr Yaqoob, Adel A. Obed
doaj +1 more source
A Single-Stage Bimodal Transformerless Inverter with Common-Ground and Buck-Boost Features
Electronics, 2023 This paper proposes a single-phase, single-stage common-ground inverter with a non-electrolytic capacitor and buck-boost ability. The proposed single-stage inverter is employed by a boost stage DC-DC converter and bimodal circuit, which makes it ...
Dai-van Vo +3 more
semanticscholar +1 more source
Performance of common-mode chokes [PDF]
, 2010 A low-cost method for experimental investigation of common-mode chokes for reducing high-frequency motor ground-currents of inverter-based drive systems of several hundred kW is presented.
Heng, Bee See, Muetze, Annette
core +1 more source
Robust H8 design for resonant control in a CVCF inverter application over load uncertainties [PDF]
, 2020 CVCF (constant voltage, constant frequency) inverters are electronic devices used to supply AC loads from DC storage elements such as batteries or photovoltaic cells. These devices are used to feed different kinds of loads; this uncertainty requires that
Bueno Contreras, Holman +2 more
core +2 more sources
Alexandria Engineering Journal, 2013 Voltage boosting is very essential issue in renewable-energy fed applications. The classical two-stage power conversion process is typically used to interface the renewable energy sources to the grid.
A. Abbas Elserougi +3 more
doaj +1 more source
Complementary Symmetry Nanowire Logic Circuits: Experimental Demonstrations and in Silico Optimizations [PDF]
, 2008 Complementary symmetry (CS) Boolean logic utilizes both p- and n-type field-effect transistors (FETs) so that an input logic voltage signal will turn one or more p- or n-type FETs on, while turning an equal number of n- or p-type FETs off.
Heath, James R. +3 more
core +1 more source
IEEE Journal of Emerging and Selected Topics in Power Electronics, 2019 This paper presents a new isolated bidirectional single-stage inverter (IBSSI) suitable for grid-connected energy storage systems. The IBSSI contains no electrolytic capacitor.
A. Haddadi, S. Farhangi, F. Blaabjerg
semanticscholar +1 more source
IEEE Access, 2023 The combination of conventional front-end DC-DC converter and H-bridge inverter has been proposed with common-ground (CG) characteristic and voltage booting capability.
Vinh-Thanh Tran +3 more
doaj +1 more source
Single phase NPC inverter controller with Integrated MPPT for PV grid connection [PDF]
, 2016 This paper presents a single-stage three-level Neutral Point Clamped (NPC) inverter for connection to the electrical power grid, with integrated Maximum Power Point Tracking (MPPT) algorithm to extract the maximum power available from solar ...
Afonso, João L. +4 more
core +1 more source