Results 101 to 110 of about 65,074 (265)
Advanced Functional Materials, EarlyView.ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
, 2015 Nanocrystalline magnesium-copper-zinc (Mg0.30Cu0.20Zn0.50Fe2O4) ferrites were prepared by microwave sintering technique. The effects of the sintering temperature on particle size and magnetic properties were investigated.
Sadhana, K. +5 more
core
Analysis and development of an aqueous tape casting ceramic process [PDF]
, 2005 The laboratory scale process developed by Navarro [Navarro, 2001 ] for the production of pyroelectric ceramics was used as a case study for the design of a high-level methodology for the scale-up of ceramic processes.
Mortara, L.
core
Advances in Sustainable and Wearable Textile Based Soft Robotics
Advanced Functional Materials, EarlyView.This Review examines advances in wearable textile‐based soft robotics, focusing on sustainable materials, integrated sensing, and scalable actuation. It discusses manufacturing and system integration across healthcare, assistive robotics, prosthetics, and human–machine interfaces, and highlights key challenges in circular design, including life‐cycle ...
Zahir Abbas +6 more
wiley +1 more source
Mechanical and Structural Properties of Microwave Sintered Tin-Copper-Antimony Alloys
, 2009 Tin-copper-antimony (pewter) alloys have been traditionally produced by a casting process which consumes large amounts of energy, time and as a result is expensive. This research aims to investigate the possibilities of implementing powder metallurgy for
Ariff, Tasnim Firdaus Binti Mohamed
core
Advanced Functional Materials, EarlyView.CuFeS2 is found to induce the formation of intermediate phases, highlighting a strong Cu–Fe synergistic effect during conversion reactions in lithium all‐solid‐state batteries (Li‐SSBs). The integrated reaction pathway effectively suppresses phase separation and accelerates reaction kinetics, leading to enhanced electrochemical reversibility and ...
Changjiang Bai +15 more
wiley +1 more source
Fabrication of finegrained Al2O3 ceramic at low sintering temperature
, 2005 A research on fabrication of finegrained Al2O3 ceramic at lower sintering temperature was carried out.Al2O3 powder with 50 nm in diameter is compounded with 11.24%Al and 4.75% Fe(mass fraction) by high-energy ball-milling.
Wang MC(王茂才) +3 more
core
Direct laser sintering of stainless steel : thermal experiments and numerical modelling [PDF]
, 2004 SLS is a commercial solid freeform fabrication process. Layers of powder material are bonded by a laser beam to rapidly manufacture three dimensional freeform models.
Taylor, Christopher Martin
core
A printed aluminum cathode with low sintering temperature for organic light- emitting diodes
, 2015 A printed aluminum cathode with low sintering temperature has been achieved using an aluminum precursor ink, AlH3 center dot O(C3H7)(2), which in the presence of a TiCl4 catalyst can be printed to give the required ...
Wu, WC(吴伟晨) +15 more
core +1 more source
Effect of sintering temperature on the microstructure and properties of Al–7.5Cu–1Si alloy
Materials Research ExpressWith increasing requirements for environmental protection and energy conservation, Al–Cu powder alloys play an important role in machine weight reduction.
Chaoyang Zhang +6 more
doaj +1 more source