Biomimetic apatite sintered at very low temperature by spark plasma sintering: Physico-chemistry and microstructure aspects [PDF]
, 2010 Nanocrystalline apatites analogous to bone mineral are very promising materials for the preparation of highly bioactive ceramics due to their unique intrinsic physico-chemical characteristics.
Champion, Eric +8 more
core +3 more sources
PENGARUH PROSES SINTERING TERHADAP PERUBAHAN DENSITAS, KEKERASAN DAN MIKROSTRUKTUR PELET U-ZrHx
Urania, 2016 ABSTRAK PENGARUH PROSES SINTERING TERHADAP PERUBAHAN DENSITAS, KEKERASAN DAN MIKROSTRUKTUR PELET U-ZrHx. Proses sintering pelet bahan bakar U-ZrHx dilakukan untuk memperoleh densitas yang lebih tinggi dari pelet sebelum disinter.
Masrukan Masrukan, Mujinem Mujinem
doaj +1 more source
Micro-/nano-scale WC particle-reinforced Cu-based composite preparation and property study
AIP Advances, 2023 In this paper, Cu-based composites were prepared by the powder metallurgy method with the spark plasma sintering (SPS) sintering technique using WC (tungsten carbide) particles as the reinforcing phase and Cu as the matrix.
Cong Chen +4 more
doaj +1 more source
Properties and Performance of High-Purity Thermal Barrier Coatings [PDF]
, 2007 It has been found that reducing the level of impurity oxides (particularly SiO2 and Al2O3) in 7YSZ, from about 0.2 wt% to below 0.1 wt% raises the sintering resistance and the phase stability of plasma-sprayed coatings.
Cipitria, A. +5 more
core +1 more source
Experimental Study on Oxygen-Enriched Sintering of Vanadium-Titanium Magnetite
Journal of Chemistry, 2018 The influences of various factors, such as oxygen enrichment time, oxygen enrichment load, and ignition temperature, on the technical indices and sintering performance in the vanadium-titanium magnetite sintering process are simulated using sinter pot ...
Hao Liu +3 more
doaj +1 more source
Effect of sintering temperature and sintering additives on ionic conductivity of LiSi2N3
Journal of the Ceramic Society of Japan, 2010 The effect of sintering temperature and sintering additives on the ionic conductivity of LiSi2N3 was studied by performing complex impedance measurements. LiSi2N3 materials were fabricated by the reaction of Li3N, Si3N4, and sintering additives at temperatures of 1873–2073 K.
Eiichirou NARIMATSU +3 more
openaire +2 more sources
Processing and Ductile-Brittle Transitions in PM Manganese Steels [PDF]
, 2005 YesBrittleness in manganese steels can be associated with processing in a "wet¿ [micro]climate resulting in the formation of continuous oxide networks.
Cias, A., Mitchell, Stephen C.
core
Densification and preservation of ceramic nanocrystalline character by spark plasma sintering [PDF]
, 2012 Spark plasma sintering is a hot pressing technique where rapid heating by dc electric pulses is used simultaneously with applied pressure. Thus, spark plasma sintering is highly suitable for rapid densification of ceramic nanoparticles and preservation ...
C Estournés +7 more
core +2 more sources
Results in Physics, 2018 The effect of grain growth via sintering temperature on some magnetic properties is reported in this research. Ni0.6Zn0.4Fe2O4 nanoparticles were mechanically alloyed for 6 h and the sintering process starting from 600 to 1200 °C with 25 °C increment ...
M.M. Syazwan +4 more
doaj +1 more source
Influence of sintering temperature on electrical conductivity of Cr3C2 sintered body.
Journal of Advanced Science, 1999 Carbide ceramics has various desirable properties, including such as a high melting point, a high hardness, the electrical conductivity, and chemical stability. In this study, Cr3C2 ceramics prepared by hot-pressing. The influence of temperature on the electrical conductivity of Cr3C2 sintered body was investigated.
Shinsuke KURIYAMA +2 more
openaire +2 more sources