Results 1 to 10 of about 1,406,259 (307)
A Novel Dual-Band Six-Phase Voltage-Control Oscillator [PDF]
Sensors, 2018 The paper presents a novel dual-band six-phase voltage-control oscillator. The voltage-controlled oscillator (VCO) with a single-ended delay cell architecture has a lower power consumption, a smaller chip area, and a larger output swing than one with a ...
San-Fu Wang, Yu-Wei Chang, Chun-Yen Tang
doaj +5 more sources
Mokslas: Lietuvos Ateitis, 2014 Multiphase electric motors have smaller torque pulsations and are more reliable that their three-phase alternatives. However, standard electricity grids around the world are three-phase, so power inverter is needed to drive multiphase motors. Inverter is
Tadas Lipinskis
doaj +4 more sources
Direct torque control for a six phase induction motor using a fuzzy based and sliding mode controller [PDF]
Scientific ReportsDirect Torque Control (DTC) is widely recognized for its fast dynamic response and simplicity in controlling induction motors. However, conventional DTC suffers from drawbacks such as high torque and flux ripple, sensitivity to parameter variations, and ...
Mohamed I. Abdelwanis +2 more
doaj +2 more sources
Effect of Winding Configuration on Six-Phase Induction Machine Parameters and Performance
IEEE Access, 2020 Six-phase induction machines have mostly shown promise in high-power electric drive applications as well as wind energy conversion systems. Different winding configurations for six-phase stators have been published, namely, dual three-phase (D3P ...
Ayman S. Abdel-Khalik +2 more
doaj +3 more sources
Control of a six-phase synchronous reluctance motor [PDF]
E3S Web of Conferences, 2022 The results of the research on control of high-speed and lowspeed six-phase synchronous reluctance motor are presented in this paper. Two control variants of SynRM are considered: two galvanically isolated three-phase windings and one six-phase winding ...
Gelver Fyodor +2 more
doaj +1 more source
Applied Sciences, 2021 A six-phase motor with a high degree of freedom can be converted into a three-phase motor in order to be used in a traction system. In addition, when phase-change technology is applied, it is possible to establish an efficient control strategy tailored ...
Daeil Hyun, Donghan Yun, Jeihoon Baek
doaj +1 more source
IEEE Access, 2021 Multiphase machines offer inherent tolerance to faults such as open converter legs (OCLs), which are especially frequent. Because of this reason, they are particularly attractive for applications where fault tolerance is important, such as offshore wind ...
Alejandro G. Yepes, Jesus Doval-Gandoy
doaj +1 more source
Implementation and Control of Six-Phase Induction Motor Driven by a Three-Phase Supply
Energies, 2021 This paper is interested in implementing and controlling a modified six-phase induction motor (MSPIM) when fed from a three-phase supply either via an inverter or with a direct grid connection loaded by a centrifugal pump.
Mohamed I. Abdelwanis +3 more
doaj +1 more source
COMPARATIVE ANALYSIS OF SIX PHASE INDUCTION MOTOR
European Journal of Technic, 2021 In recent years, AC induction motors have replaced DC motor. The most important reason for this is that DC motors have a mechanical brush and commutator system that is subject to wear and tear over time. While DC motor drivers need a lot of maintenance due to this system, induction motors do not require almost any maintenance since this system is not ...
SARIGÜL, İsmail, ÖZDEMİR, Mehmet
openaire +3 more sources
IEEE Access, 2020 In this paper, a novel N+2 power converter is introduced and be applied to a six-phase switched reluctance motor (SRM) drive system. Compared with six-phase asymmetric half bridge (AHB) converter, the number of power devices required by this N+2 ...
Minjun Guan +3 more
doaj +1 more source