Results 171 to 180 of about 152,949 (296)

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

Design optimization and real-time implementation of an LSPMSM for efficiency enhancement. [PDF]

Sci Rep
Ocak C, Yenipınar B, Çelik E, Abdel-Salam M, Tejani GG, Mousavirad SJ.   +5 more
europepmc   +1 more source

A Thermodynamic 3D Model for the Simulation of Diffusion‐Controlled Alloying Processes in Heterogeneous Material Structures

Advanced Engineering Materials, EarlyView.
A numerical model resulting from irreversible thermodynamics for describing transport processes is introduced, focusing on thermodynamic activity gradients as the actual driving force for diffusion. Implemented in CUDA C++ and using CalPhaD methods for determining the necessary activity data, the model accurately simulates interdiffusion in aluminum ...
Ulrich Holländer, Leonhard Holländer, André Langohr, Hans Jürgen Maier   +3 more
wiley   +1 more source

Glycoprotein Non-Metastatic Melanoma Protein B (GPNMB): A Translational Pharmacodynamic Biomarker for PIKfyve Inhibition With VRG50635. [PDF]

Clin Transl Sci
Gontier G, Kim G, Wang C, Zhu K, Gau R, Zhang N, Naphade S, Stewart A, Schmidt MJ, Galemmo R, Shook B, Tarachandani A, Choi I, Raines S, Scannevin RH, Grievink HW, Smits LMG, Kremer PHC, Cadavid D.   +18 more
europepmc   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

Multivector model predictive control for multiphase induction machines with dead-time knowledge. [PDF]

Sci Rep
Carrillo-Rios J, Cordoba-Ramos M, Lara-Lopez R, Gonzalez-Prieto I, Duran MJ, Aciego JJ, Mora-Moreno P, Gonzalez-Prieto A.   +7 more
europepmc   +1 more source

Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories

Advanced Engineering Materials, EarlyView.
Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter, Felix Drechsler, Till M. J. Stadtmüller, Cameliu Himcinschi, Christos G. Aneziris, Jens Kortus   +5 more
wiley   +1 more source

Analysis of Stator Material Influence on BLDC Motor Performance. [PDF]

Materials (Basel)
Ziemiański D, Chwalik-Pilszyk G, Dudzik G.   +2 more
europepmc   +1 more source

Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena, Benjamin Bergmann, Michael Zenger   +2 more
wiley   +1 more source

Experimental validation of MRAS sensorless direct torque control using ANN for induction motors in a pumping system. [PDF]

Sci Rep
Ech-Chaouy H, Derouich A, Mahfoud S, Mosaad MI, Tazay AF.   +4 more
europepmc   +1 more source