Results 51 to 60 of about 2,188 (203)

Electrolyte Design for Fast‐Charging Lithium‐Based Batteries

Advanced Materials, EarlyView.
A decade of progress in fast‐charging electrolytes for lithium batteries is reviewed. Electrolyte design strategies spanning solvents, salts, additives, and advanced systems, such as localized high‐concentration electrolytes (LHCEs), are summarized. Advanced diagnostic tools for lithium plating and interphase chemistry are discussed, with perspectives ...
Chen Liu, Zehao Cui, Arumugam Manthiram
wiley   +1 more source

Large‐Scale and Cost‐Effective Fabrication of Ultra‐Thin, Biodegradable Microelectrode Arrays and Pressure Sensors Using Laser Micromachining

Advanced Materials Technologies, EarlyView.
A mask‐free and cost‐effective UV‐pico‐second laser‐based microfabrication method is proposed to fabricate large‐area biodegradable microelectrode arrays and pressure sensors. These devices demonstrate low impedance, good conformability, excellent biocompatibility, and rapid degradation, providing a new route for next‐generation transient electronics ...
Bhavani Prasad Yalagala, Asfand Tanwear, María Cerezo‐Sánchez, Hossein Parvizi, Morteza Amjadi, Hadi Heidari   +5 more
wiley   +1 more source

Evolution of OLED Lamination Technology With Development of Display Form Factors

Advanced Materials Technologies, EarlyView.
This review evaluates the evolution of organic light‐emitting diode (OLED) lamination technologies alongside advancing display form factors. It contrasts optically clear adhesives and resins, highlighting uniformity control for rigid screens, bubble‐free optimization for bended architectures, and visible‐light curing for foldable layers.
Kwan‐Young Han, Ji‐Hoon Park
wiley   +1 more source

Coating‐Free Nanoscratching for Liquid‐Crystal Alignment on PCB‐Compatible Millimeter‐Wave Reflective Unit Cells

Advanced Materials Technologies, EarlyView.
Direct nanoscratching with a 500 nm diamond lapping film creates groove‐guided liquid‐crystal alignment interfaces on PCB‐compatible Cu‐patterned RF substrates within minutes, eliminating polymer coating and high‐temperature baking. The coating‐free process enables optical/molecular alignment validation and voltage‐programmable 28 GHz reflection‐phase ...
Junseok Ma, Ga‐Yeong Park, Geunjung Lee, Hyo‐Won Lee, Jong‐Won Yu, Dong Ki Yoon   +5 more
wiley   +1 more source

Defect‐Engineered ZnO Nanowire Arrays for Flexible Room‐Temperature Hydrogen Sensors

Advanced Materials Technologies, EarlyView.
Fabrication process of patterned ZnO nucleation sites on a flexible polyimide (PI) substrate. Top/tilted‐view SEM images of ordered ZnO nanoflower arrays confined within patterned circular regions. AFM topography map with height data revealing a disk‐array structure, where the patterned regions (marked by a red dot circle) are elevated by ∼2 µm ...
Jun‐Ting Wang, Imran Khan, Jhen‐De You, Fan‐Hua Kong, Chang‐Mou Wu, Po‐Kai Chiu, Ray‐Hua Horng, Jinn P. Chu   +7 more
wiley   +1 more source

Microfabrication of Soft Millirobots Propelled by Low Voltage Electrohydraulic Actuators

Advanced Materials Technologies, EarlyView.
Manual layer‐by‐layer assembly is replaced by wafer‐level MEMS batch fabrication for compliant polymer‐based electrohydraulic actuators. The microfabricated devices integrate sacrificially defined microcavities, Parylene‐C‐sealed inlets, and multilayer polymer–metal films.
Shai Shmulevich, Florian Hartmann, Herbert Shea   +2 more
wiley   +1 more source

Hydrophobic 1D and 3D Anodic Alumina Radiative Coolers on Aluminum: Humidity‐Resilient Daytime Sub‐Ambient Cooling

Advanced Optical Materials, EarlyView.
1D and 3D nanoporous anodic aluminum oxide (AAO) surfaces were functionalized with stearic acid (STA) to increase hydrophobicity and reduce the influence of humidity on radiative cooling performance. The STA coating improves cooling behavior under humid atmospheric conditions (Madrid summer), before while keeping the optical properties required for ...
Luis Moreno‐Sanabria, Carlos G. Cobos, Nadia Pastor, Marisol Martín‐González, Cristina V. Manzano   +4 more
wiley   +1 more source

Enhanced Operational Stability of Carbene‐Metal‐Amide Organic Light‐Emitting Diodes by Reducing Electron Accumulation on the Emitter

Advanced Optical Materials, EarlyView.
Carbene‐metal‐amide (CMA) organic LEDs suffer from poor stability despite submicrosecond excited‐state lifetimes. Here, we show that electron accumulation on CMA emitters triggers bond cleavage, while poor electron transport amplifies OLED instability.
Rishabh Saxena, J. Terence Blaskovits, Alexander C. Brannan, Alexander Romanov, Seah Ling Kuan, Hans Joachim Räder, Denis Andrienko, Paul W. M. Blom, Gert‐Jan A. H. Wetzelaer   +8 more
wiley   +1 more source

Nonlocomotory Robotic Strategies for Dynamic Rotation Control in Terrestrial Robots: A Review

Advanced Robotics Research, EarlyView.
Terrestrial robots increasingly require rapid body rotation to maintain stability and agility in complex environments. This review shows nonlocomotory rotational control strategies that operate without ground contact, including reaction wheels, tails, bars, limbs, and thrusters.
Y. Liang, J. An, X. Zheng, D. Wang, S. Wang, X. Wang, P. Zhu, J. Pei, S. Li, J. Paripurana, Y. Han, Z. Tang, X. Gan, Q. He, X. Ma   +14 more
wiley   +1 more source

Multimodal Locomotion in Insect‐Inspired Microrobots: A Review of Strategies for Aerial, Surface, Aquatic, and Interfacial Motion

Advanced Robotics Research, EarlyView.
This review identifies key design considerations for insect‐inspired microrobots capable of multimodal locomotion. To draw inspiration, biological and robotic strategies for moving in air, on water surfaces, and underwater are examined, along with approaches for crossing the air–water interface.
Mija Jovchevska, Kaushik Jayaram, Nicole Xu   +2 more
wiley   +1 more source