Results 31 to 40 of about 9,588 (274)
Case Studies in Construction Materials, 2023 This paper studied the openings' influences on the structural responses of interior voided slab-column connections. Seven specimens were constructed with square slabs measuring 1100 × 1100 × 100 mm and contained voids distributed throughout their entire ...
Haider J. Hammood +3 more
doaj +1 more source
Reinforced concrete slab-column edge connections with shear studs [PDF]
, 2000 The paper reports the results of an experimental investigation on the influence of shear studs on the behaviour of reinforced concrete slab-column edge connections with openings.
Ehab F El-Salakawy +2 more
core +1 more source
Effect of load level of corner columns on punching shear resistance of flat slabs
Budownictwo i Architektura, 2020 The problem related to the effect of the corner column load on the punching shear resistance of the slab was presented. Existing experimental studies on internal columns demonstrated that the column pressure could lead to an increase in the punching ...
Michał Gołdyn, Tadeusz Urban
doaj +1 more source
Seismic behaviour of slab-column connections without transverse reinforcement [PDF]
, 2016 Reinforced concrete (RC) flat slabs supported by slender columns are often used as gravity load resisting system for buildings in regions of moderate and high seismicity. Such buildings are typically braced by RC walls, which carry the largest portion of
Drakatos, Ioannis Sokratis
core +1 more source
MATEC Web of Conferences, 2018 This research investigates the effect of unbalanced moment directions on the behaviour of edge column slab connections using a finite element analysis.
Sudarsana I Ketut +2 more
doaj +1 more source
Punching strength of flat slabs with shear reinforcement: considerations about the control perimeters [PDF]
Revista IBRACON de Estruturas e MateriaisIn structural design practice and scientific research on flat slabs, estimating the punching shear resistance of slab-column connection with shear reinforcement involves checking the shear stress acting on a control perimeter outside the shear-reinforced
Marcos Honorato Oliveira +5 more
doaj +1 more source
Polymorph‐Specific Electronic Transduction in WO3 during Molecular Sensing
Advanced Materials, EarlyView.Metal‐oxide polymorphs with similar surface chemistry can nevertheless exhibit distinct sensing properties. In γ‐ and ε‐WO3, analyte adsorption appears comparable; yet, only ε‐WO3 induces a pronounced lattice electronic perturbation that accommodates charge in sub‐conduction band minimum states.
Matteo D'Andria +6 more
wiley +1 more source
Parametric design method of building structured cabling system oriented to data mining
IET Networks, EarlyView., 2022 This paper puts forward the method of secondary development and design software through the research of building structured cabling system (SCS), and uses data mining technology to carry out parametric design of building SCS. Then, the feasibility of the design is tested by comparing the data of the traditional design and the parametric design ...
Bing Wang, Wei Yue
wiley +1 more source
Semi rigid connections and their influence on steel column behaviour. [PDF]
, 1980 A review of the development of the analysis of frames with semi-rigid end restraint is given, including the treatment of frame stability and effective lengths. The available experimental data relating to the moment versus in-plane
Jones, Stephen Winford
core
Advanced Materials Technologies, EarlyView.Liquid metal direct writing is advanced from a technological and fundamental point. Utilizing a kinematic bed, printing on large surfaces with irregularities is enabled. Furthermore, a pressure‐driven flow during printing is discovered that affects the thickness of traces.
Maximilian Krack +15 more
wiley +1 more source