Results 31 to 40 of about 2,142 (118)
Numerical Study on Static Airtightness of Subway Vehicles with Multiple Leak Holes [PDF]
Journal of Applied Fluid MechanicsIn this study, a numerical simulation of the static leakage of a subway vehicle was conducted, based on the turbulence model of k-ω Shear Stress Transport (SST).
N. Li, H. Meng, T. Li, J. Zhang
doaj +1 more source
Analysis of the backward bending modes in damped rotating beams
Advances in Mechanical Engineering, 2019 This article presents a study of the backward bending mode of a simply supported rotating Rayleigh beam with internal damping. The study analyses the natural frequency behaviour of the backward mode according to the internal viscous damping ratio, the ...
Jose Martínez-Casas +4 more
doaj +1 more source
Instability analysis of a filament-wound composite tube subjected to compression/bending
Advanced Composites Letters, 2019 The aim of this study is to investigate the global buckling of a relatively long composite cord–rubber tube subjected to axial compression and its cross-sectional instability due to bending by a macromechanical nonlinear finite element (FE) model ...
Gyula Szabó, Károly Váradi
doaj +1 more source
Ultimate strength of simply supported plate with opening under uniaxial compression
International Journal of Naval Architecture and Ocean Engineering, 2012 Unstiffened plates are integral part of all kinds of structures such as ship and offshore oil platforms. Openings are unavoidable and absolutely reduce the ultimate strength of structures.
Chang-Li Yu, Joo-Sung Lee
doaj +1 more source
Journal of the Mechanical Behavior of Materials, 2022 This study presents the findings of a 3D finite element modeling on the performance of a single pile under various slenderness ratios (25, 50, 75, 100).
Al-Jeznawi Duaa +3 more
doaj +1 more source
Experimental and numerical investigation on the axial compressive behavior of UPVC square tubes
Results in EngineeringUPVC (Unplasticized Polyvinyl Chloride) is a novel construction material. Currently, there is a lack of comprehensive research on the fundamental mechanical properties of this material, particularly regarding UPVC square tubes, for which studies are ...
Shuquan Xu +4 more
doaj +1 more source
Advances in Civil Engineering, 2020 This study presents a finite element model to investigate the bidirectional seismic behavior of masonry infill walls. The test data are utilized to verify the numerical model.
Xiaomin Wang +3 more
doaj +1 more source
International Journal of Concrete Structures and Materials, 2020 The flexural behavioral properties of ultra high performance concrete (UHPC) low-profile T-beams reinforced with a combination of steel fibers and steel reinforcing bars were investigated in this paper.
Minghong Qiu +4 more
doaj +1 more source
Considerations Concerning the Impact of the Management on Pine Trees Drying Phenomenon
Bulletin of University of Agricultural Sciences and Veterinary Medicine Cluj-Napoca: Agriculture, 2016 The pine trees may support the consequences of the action of a series of various natural harmful factors, as break downs determined by strong winds, storms, or large amounts of snow, pathogens and mites’ attacks, and also anthropogenic harmful factors ...
Ilie Covrig +3 more
doaj +1 more source
Correction of water-penetrating velocity attenuation formula for “Pie” fragment
Zhongguo Jianchuan Yanjiu, 2019 [Objectives]Fragment is the key object of vessel liquid tank protection, and the study on the water-penetrating velocity attenuation characteristic of the high-speed "pie" fragment can provide theoretical reference for the protection analysis and ...
Zhang Lei +4 more
doaj +1 more source