Results 11 to 20 of about 3,578,019 (193)

An Improved Optimal Slip Ratio Prediction considering Tyre Inflation Pressure Changes [PDF]

open access: yesJournal of Control Science and Engineering, 2015
The prediction of optimal slip ratio is crucial to vehicle control systems. Many studies have verified there is a definitive impact of tyre pressure change on the optimal slip ratio.
Guoxing Li   +4 more
doaj   +2 more sources

An Improved Adaptive Sliding Mode Control Approach for Anti-Slip Regulation of Electric Vehicles Based on Optimal Slip Ratio

open access: yesMachines
To optimize the acceleration performance of independently driven electric vehicles with four in-wheel motors, this paper proposes an anti-slip regulation (ASR) strategy based on dynamic road surface observer for more efficient tracking of the optimal ...
Houzhong Zhang   +3 more
doaj   +2 more sources

Thermal rarefied gas flow investigations through micro/nano backward-facing step : Comparison of DSMC and CFD subject to hybrid slip and jump boundary conditions [PDF]

open access: yes, 2014
This paper evaluates the suitability of a newly developed hybrid “Langmuir-Maxwell” and “Langmuir-Smoluchowski” slip/jump boundary conditions in the Navier-Stokes-Fourier equations for nano/micro backward-facing step geometry flow which experiences ...
White, Craig   +3 more
core   +3 more sources

Sustainability of apparent slip in micro-channel flows [PDF]

open access: yes, 2011
This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
Pawar, PS   +3 more
core   +6 more sources

Change in drag, apparent slip and optimum air layer thickness for laminar flow over an idealised superhydrophobic surface [PDF]

open access: yes, 2013
Analytic results are derived for the apparent slip length, the change in drag and the optimum air layer thickness of laminar channel and pipe flow over an idealised superhydrophobic surface, i.e. a gas layer of constant thickness retained on a wall.
Newton, M.I.   +13 more
core   +1 more source

The effect of slip length on vortex rebound from a rigid boundary [PDF]

open access: yes, 2013
The problem of a dipole incident normally on a rigid boundary, for moderate to large Reynolds numbers, has recently been treated numerically using a volume penalisation method by Nguyen van yen, Farge, and Schneider [Phys. Rev.
Dritschel, D.G.   +6 more
core   +1 more source

Efficient Break-Away Friction Ratio and Slip Prediction Based on Haptic Surface Exploration [PDF]

open access: yes, 2014
The break-away friction ratio (BF-ratio), which is the ratio between friction force and the normal force at slip occurrence, is important for the prediction of incipient slip and the determination of optimal grasping forces. Conventionally, this ratio is
Liu, H   +9 more
core   +1 more source

Computational Analysis of Wall Slip and Cavitation in Lubricated Sliding Systems [PDF]

open access: yes, 2012
Lubrication is applied to systems in which parts are in relative motion to avoid direct contact between the surfaces. The behavior of the fluid-film in sliding bearings depends on the boundary conditions at the interface between the liquid and the ...
M, Muchammad   +3 more
core   +1 more source

Aircraft Anti-Skid Brake Control Based on High-Speed on-off Valve

open access: yesMATEC Web of Conferences, 2015
Aircraft hydraulic brake system usually use pressure servo valve for anti-skid brake control. As pressure servo valve realizes the pressure closed loop by hydraulic feedback loop, this structure increased the complexity of the processing and ...
Li Wei, Zhang Hu, Huang Xiaoya
doaj   +1 more source

Simulation of Electric Truck Brake System Operating in Industrial Plants

open access: yesTạp chí Khoa học và Công nghệ, 2023
This study analyzes the quarter car braking model to determine the effect of the wheel slip ratio (λ) on  the friction coefficient (µ) during the braking of the car.
Minh Duc Le   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy