Results 81 to 90 of about 384,010 (303)
Advanced Engineering Materials, EarlyView.Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente +3 more
wiley +1 more source
CrystalsHerein, the corrosion performance of different stainless steel (SS) reinforcing bar grades in alkaline solution is presented, including UNS S32205 duplex stainless steel (DSS), UNS S32304 and UNS S32001 lean DDS (LDSS).
Ulises Martin, David M. Bastidas
doaj +1 more source
Advanced Engineering Materials, EarlyView.Fungal mycelia grown into biodegradable scaffolds and infused with titania nanoparticles show enhanced ultraviolet shielding, thermal protection, and surface nonwettability. Properties were tuned by drying methods, revealing structure–function relationships.
Juwon S. Afolayan +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Phase‐changing liquids enable untethered pneumatic actuation in soft robotics but suffer from volatility and storage challenges. This work reports a simple method to encapsulate Novec 7000 within micron‐thin alginate shells via in situ injection and ionic crosslinking.
Rayan A. M. Basodan +3 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Stress Corrosion Cracking Test with Slow Strain Rate and Constant Current
, 1979 A rapid electrochemical tension test was developed for evaluating stress corrosion crack initiation in carbon steel. Constant anodic current was imposed on smooth-bar tension specimens as the specimens were slowly strained to fracture at 1.3 × 10-6/s. Equivalent results were obtained for the following ductility properties measured: uniform elongation ...
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source
Experimental study on dynamic strength and crack evolution of rocks under different strain rates
Meikuang AnquanThe study on the dynamic mechanical characteristics of rocks under impact loading holds significant theoretical guiding significance for achieving controlled blasting during roof cutting blasting.
Tao PAN, Xiao LIU
doaj +1 more source
Advanced Engineering Materials, EarlyView.Phase‐field simulations coupled with dislocation‐density‐based crystal plasticity modeling reproduce γ′ rafting behavior in single‐crystal Ni‐based superalloys under varied loading conditions. The model captures both macroscopic creep and microscopic morphology evolution, with results matching high‐temperature creep experiments.
Micheal Younan +5 more
wiley +1 more source
Effect of Elastic and Plastic Strain on Corrosion Behavior of X90 Pipeline Steel
Liaoning Shiyou Huagong Daxue xuebaoThe effect of elastic and plastic strain on corrosion behavior of X90 pipeline steel in a simulated marine alternating dry/wet environment was investigated by means of slow strain rate tensile test, in?situ electrochemical measurement, scanning electron ...
Songyuan BAI, Dongxu SUN, Ming WU
doaj +1 more source