Results 101 to 110 of about 1,945 (252)
Time Management in Circular Construction: A Systematic Review of Secondary Materials Integration
ABSTRACT The transition of the building and construction industry towards a circular economy (CE) increasingly relies on the integration of secondary materials. This integration can disrupt the traditional cost, time and quality metrics of project success.
Soheila Ghafoor +5 more
wiley +1 more source
Stream Discharge Determinations Using Slug Additions and Specific Conductance
Stream discharge is often determined by wading the stream and measuring the point velocity at fixed widths and depths. However, there are conditions when wading measurements are not safe or the measurements are poor because of high turbulence, rocky ...
R. Blaine McCleskey +3 more
doaj +1 more source
Cyanated carbon dots (CN‐CDs) are synthesized by the hydrothermal method with carboxymethyl cellulose and cyanobenzoic acid, and CD‐CTN is obtained in situ via cyclotrimerization of CN‐CDs. CD‐CTN possesses excellent photothermal catalytic H2O2 production in seawater, and desalted H2O2 could be obtained, which demonstrates the practical application for
Xiaoxia Chen +13 more
wiley +1 more source
Peroxodisulfate‐Enhanced Leaching of Deep‐Sea Manganese Crusts and Sulfides
Ammonium peroxodisulfate enables efficient leaching of deep‐sea manganese crusts and massive sulfides while offering electrolytic recycling. High leaching yields for V, Mn, Co, Mo, Sn, and W, along with complete leaching of As and Sb, highlight its potential as a powerful and sustainable oxidant for marine resource processing.
Bastian Hansel +5 more
wiley +1 more source
Abstract Engineering graduate students confuse the scientific method and problem solving when presenting their pre‐doctoral exams and theses: Science discourse adopts question and hypotheses to assert and establish a study's rationale, while it is problem and objectives in engineering design.
Gregory S. Patience +4 more
wiley +1 more source
Demulsifying agent simplified model for offshore oil wells
Abstract This article addresses key challenges in offshore petroleum production caused by multiphase flow instabilities, such as slug flow and emulsion formation. Traditionally, severe slugging is mitigated by increasing wellhead backpressure through partial choke valve closure. In this context, a simplified dynamic model—the fast offshore wells model (
Fernanda Bernardi de Souza +5 more
wiley +1 more source
Abstract Severe slugging represents a major challenge in offshore production systems, potentially compromising operational stability and the integrity of installations. Although established simulators such as OLGA® are widely used for its analysis, there is a gap in the literature regarding the application of the one‐dimensional simulator ALFAsim® for ...
Wayne Gabriel Nóbrega Firme +4 more
wiley +1 more source
Fered–Fenton treatment of saline produced water: generation of reactive oxygen species and enhanced degradation of cyclohexane carboxylic acid through in‐situ electrochemical Fenton reactions. Abstract Offshore oilfield produced water (OPW) is a highly complex and hypersaline effluent from oil and gas extraction industry.
Daniela Gier Della Rocca +7 more
wiley +1 more source
A co‐designed implicit‐reset phase‐frequency detector (PFD) and nonlinear amplifier‐assisted charge pump (CP) achieve dead zone‐free operation from 10 MHz to 4.7 GHz with < 0.5% current mismatch without calibration, enabling −80 dBc of reference spur and 0.50 ps of RMS jitter in a 180 nm of CMOS PLL.
A. Ghaemnia +3 more
wiley +1 more source
This paper presents temporal and adaptive‐frequency network with MixStyle (TAMNet), a deep time‐series modeling framework for accurate and robust multi‐well oil productivity forecasting. TAMNet integrates transformer and long short‐term memory architectures to capture both short‐ and long‐term temporal dependencies, enhanced by a temporal gate unit ...
Chunxi Yang +6 more
wiley +1 more source

