Results 191 to 200 of about 577,675 (243)
Some of the next articles are maybe not open access.
, 2020
In this work, we fabricate nanostructured, bimodal, and multimodal WC-10Co4Cr coatings via two high velocity oxy-fuel (HVOF) systems and investigate the coatings’ microstructure, mechanical, electrochemical properties and slurry erosion resistance in 3.5
Y. Huang +4 more
semanticscholar +1 more source
In this work, we fabricate nanostructured, bimodal, and multimodal WC-10Co4Cr coatings via two high velocity oxy-fuel (HVOF) systems and investigate the coatings’ microstructure, mechanical, electrochemical properties and slurry erosion resistance in 3.5
Y. Huang +4 more
semanticscholar +1 more source
The effect of impingement angle on slurry erosion
Wear, 1991Abstract The slurry erosion behaviour of metallic and non-metallic materials eroded by sand and water slurry was investigated. Under different test conditions, the erosion behaviour of the two kinds of materials followed two different patterns. A graph of erosion rate vs. impingement angle for metallic materials showed two peaks and a trough, whereas
Lin Fuyan, Shao Hesheng
openaire +1 more source
, 2020
The socio-economic development of any country is completely dependent on the energy and the demand for energy is not completely fulfilled from a single source.
Gaurav Prashar +2 more
semanticscholar +1 more source
The socio-economic development of any country is completely dependent on the energy and the demand for energy is not completely fulfilled from a single source.
Gaurav Prashar +2 more
semanticscholar +1 more source
Erosion damage of polymeric material by slurry
Wear, 1986Abstract An attempt was made to reveal the erosion mechanism of a plastic material in slurry containing glass beads of approximately 176 μm in diameter. The experimental observations were interpreted in terms of parameters such as the impact velocity Vp, the impact angle α of the beads and the striking efficiency η.
Hidemitsu Hojo, Ken Tsuda, Tomohiko Yabu
openaire +1 more source
Journal of materials engineering and performance (Print), 2023
Rajat Vipra +8 more
semanticscholar +1 more source
Rajat Vipra +8 more
semanticscholar +1 more source
The Control of Erosion-Corrosion in Slurry Pipelines
CORROSION 1987, 1987Abstract The results of erosion-corrosion testing in pilot plant slurry pipelines are related to the behaviour of operating slurry pipelines and the control of erosion-corrosion in such systems by use of inhibitors, solution conditioning and adjustment of slurry parameters. The erosion-corrosion component of the total wear
openaire +1 more source
On the particle size effect in slurry erosion
Wear, 1991Abstract The erosion rates of cylindrical steel specimens tested at a constant speed of 18.7 m s −1 in an erosion pot tester using 1.2 wt.% suspension of SiC in oil for particle diameters between 20 and 500 μm have been determined. The rate of particle impact on unit area of the surface at the stagnation line of erosion specimens was established as ...
Randall S. Lynn +2 more
openaire +1 more source
Erosion Wear in A Slurry Pipe With Multisized Coal And Bottom-Ash Slurries
Materials Today: Proceedings, 2017Abstract Presently, Erosion wear is one of the major problems in slurry transportation system affecting both initial cost and life of its components. In the present work, erosion wear due to solid–liquid mixture flow has been studied using a slurry erosion pot tester.
Gurprit Singh +2 more
openaire +1 more source
Effect of Coating Thickness on the Slurry Erosion Resistance of HVOF-Sprayed WC-10Co-4Cr Coatings
Journal of thermal spray technology (Print), 2021S. Sapate +6 more
semanticscholar +1 more source