Results 191 to 200 of about 488,986 (317)

Heat-Not-Burn Tobacco Cigarettes: Smoke by Any Other Name

open access: yesJAMA Internal Medicine, 2017
R. Auer   +4 more
semanticscholar   +1 more source

Elastomers Combining Damping Efficiency With Rapid Recovery

open access: yesAdvanced Materials Technologies, EarlyView.
Double network granular elastomers (DNGEs) combine high energy dissipation under both cyclic loading and high impact with rapid shape recovery. 3D printing enables the production of complex, customizable structures with tailored performance. Recyclable DNGEs retain their properties over multiple recycling cycles.
Eva Baur, Alain Molleyres, Esther Amstad
wiley   +1 more source

Smart and Sustainable Sizing: Investigating the Sensing Behavior of Glass Fabrics Coated With Waterborne Polyurethane/Graphene Dispersions

open access: yesAdvanced Materials Technologies, EarlyView.
Waterborne polyurethane/graphene formulations are developed as piezoresistive coatings on glass fabric to enable flexible strain sensing. The graphene‐enabled conductive network provides a stable electromechanical response under cyclic compression. The coating demonstrates reliable pressure‐dependent resistance changes, highlighting its potential for ...
Vishnu Vijayan Pillai   +8 more
wiley   +1 more source

Benchmarking Coaxial and Angular Optical Emission Spectroscopy With Recommendations for Reliable Compositional In Situ Monitoring During Laser Powder Bed Fusion

open access: yesAdvanced Materials Technologies, EarlyView.
ABSTRACT Real‐time insight into local chemistry is critical for reliable part quality in additive manufacturing, especially laser powder bed fusion (PBF‑LB/M), where rapid thermal cycles and localized evaporation can undermine part performance. Optical emission spectroscopy (OES) offers non‑intrusive, in situ plume monitoring, but detection geometry ...
Philipp Gabriel   +4 more
wiley   +1 more source

Additive Manufacturing of Patient‐Specific Intracranial Aneurysm Cell Culture Models

open access: yesAdvanced Materials Technologies, EarlyView.
Patient‐specific intracranial aneurysm models were fabricated using chocolate moulding, 3D printed water‐soluble cores, and direct resin 3D printing. Moulding PDMS around sacrificial cores made of chocolate or 3D printed water‐soluble resin yielded accurate, expandable, and endothelializable models that outperformed resin‐based approaches.
Chloe M. de Nys   +6 more
wiley   +1 more source

Decoupling the Impact of Deep‐Trap and Band‐Tail States on PbS Quantum Dot Photodetectors via Alkylamine Engineering

open access: yesAdvanced Materials Technologies, EarlyView.
Band‐tail and deep trap states are effectively disentangled through the use of selective alkylamine additives. PA‐driven 2D ordering narrows band tails, while HA enhances halide passivation and Pb coordination to suppress deep traps. A comparative study of their CQD short‐wave infrared (SWIR) photodetectors further reveals whether band‐tail states or ...
Huaying Zhong   +14 more
wiley   +1 more source

CT findings in biomass smoke-associated interstitial lung disease: A retrospective analysis. [PDF]

open access: yesJ Clin Imaging Sci
Bendetson JG   +5 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy