Results 21 to 30 of about 55,388 (315)
Interface modification and performance optimization of SnO2 based perovskite solar cells
工程科学学报, 2023 Over the past decade, the power conversion efficiency of perovskite solar cells has increased from 3.8% to the current 25.5%, which is expected to become the next generation of commercial thin-film solar cells.
Zhi-peng WANG +3 more
doaj +1 more source
Impedance spectroscopy in H2 sensing with TiO2/SnO2 nanomaterials
Metrology and Measurement Systems, 2020 Alternating current a.c. measurements enable to understand the physical and chemical processes occurringin semiconductor materials. Impedance spectroscopy has been successfully applied to study the responsesof gas sensors based on metal oxides, such as ...
Bartłomiej Szafraniak +3 more
doaj +1 more source
Facile synthesis of hierarchical CNF/SnO2/Ni nanostructures via self-assembly process as anode materials for lithium ion batteries [PDF]
Royal Society Open Science, 2018 Hierarchical carbon nanofibre (CNF)/SnO2/Ni nanostructures of graphitized carbon nanofibres and SnO2 nanocrystallines and Ni nanocrystallines have been prepared via divalent tin–alginate assembly on polyacrylonitrile (PAN) fibres, controlled pyrolysis ...
Haitong Tang +5 more
doaj +1 more source
STRUKTUR KRISTAL DAN MORFOLOGI PERMUKAAN – SINTESIS SNO2 MENGGUNAKAN METODE SOL-GEL
Rekayasa Mesin, 2022 SnO2 oxide powder was synthesized using the sol-gel method. SnO2 oxide powder was produced using a solution of tin(IV) chloride (SnCl4) and 25% ammonia (NH4(OH)) by annealing the final product for 4 hours at 900 °C. The pH variation was carried out at pH
Tri Arini +6 more
doaj +1 more source
Reduction behavior of Tin-containing phase in Tin-bearing iron concentrates under CO-CO2 mixed gases [PDF]
Journal of Mining and Metallurgy. Section B: Metallurgy, 2019 The main purpose of this study was to ascertain the reduction behavior of tin phase (SnO2) in tin-bearing iron concentrates at the respective temperature of 1273 and 1373 K in diverse CO-CO2 mixed gases using chemical analysis, XRD, and SEMEDS analysis ...
Yu Y., Li H.-J., Li L.
doaj +1 more source
Journal of Experimental Nanoscience, 2020 This study investigated the removal of phosphorus (PO4−3-P) from water samples by SnO2 and WO3 nanoparticles (NPs). The effects of adsorbent dosage, pH, contact time and temperature with an initial concentration of 50 mg L−1 of P were investigated.
Shahriar Mahdavi +2 more
doaj +1 more source
SnO2 Layer Treatment with Thioacetamide in Perovskite Solar Cell [PDF]
Nanochemistry Research, 2023 The electron transport layer plays a pivotal role in shaping the photovoltaic attributes of perovskite solar cells. SnO2 stands out as an exemplary electron transport layer for perovskite solar cells due to its exceptional carrier mobility, deep ...
Fatemeh Ghasemi +2 more
doaj +1 more source
Fabrication and characterization of SnO2 and SnS2 nanobiosensor in the Presence of Aspergillus Niger Fungi [PDF]
Nanomedicine Research Journal, 2019 In this paper, SnO2 and SnS2 thin films were prepared by spray pyrolysis technique on glass substrate. The prepared films were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Aspergillus niger (A.
Reihane Etefagh +5 more
doaj +1 more source
Bulletin of Materials Science, 2011 This paper reports the synthesis of SnO2-CuO, SnO2-Fe2O3 and SnO2-SbO2 composites of nano oxides and comparative study of humidity sensing on their electrical resistances. CuO, Fe2O3 and SbO2 were added within base material SnO2 in the ratio 1: 0.25, 1: 0.50 and 1: 1. Characterizations of materials were done using SEM and XRD.
B. C. Yadav, Preeti Sharma, P. K. Khanna
openaire +2 more sources
Transition metal elements-doped SnO2 for ultrasensitive and rapid ppb-level formaldehyde sensing
Heliyon, 2023 Pristine SnO2, Fe-doped SnO2 and Ni-doped SnO2 were synthesized using facile hydrothermal method. Analysis based on XRD, TEM and UV–Vis DRS measurements demonstrated the successful insertion of Fe and Ni dopants into SnO2 crystal.
Zejun Han +11 more
doaj +1 more source