Results 151 to 160 of about 18,096 (313)
Advanced Materials Technologies, EarlyView.Parallel wiring of bioelectrochemical devices with conventional generators unexpectedly boosts output. A biophotovoltaic paired with a solar cell delivers up to 50% more power at low loads than their separate contributions; a plant microbial fuel cell shows similar current gains.
Valeria Marsaglia +4 more
wiley +1 more source
Large Deformation Plate Bending with Application to Solar Collectors
, 2008 In a typical trough solar collector, a reflective sheet is shaped by a set of ribs with parabolic cutouts. This paper proposes the alternative simple construction method of pushing a thin elastic plate inwards on opposite edges, allowing the plate to ...
Savvides, N, Lovatt, HC, Watterson, PA
core
Advanced Materials Technologies, EarlyView.Transducers convert physical signals into electrical and optical representations, yet each mechanism is bounded by intrinsic trade‐offs across bandwidth, sensitivity, speed, and energy. This review maps transduction mechanisms across physical scale and frequency, showing how heterogeneous integration and multiphysics co‐design transform isolated ...
Aolei Xu +8 more
wiley +1 more source
Solar collector efficiency testing unit
, 2012 This project concentrates on the development and testing of the solar efficiency unit. This was achieved by defining the capabilities of the system, and developing a control strategy to control the temperature and flow rate of the fluid leaving the unit.
Alasi, Amer
core
Advanced Materials Technologies, EarlyView.Halide perovskite solar cells are fabricated with self‐encapsulation by lamination between two glass substrates using rapid Joule heating, yielding a 99% reduction in lamination time compared to previous studies. An 18% efficient cell is laminated in 5 s, demonstrating the potential for scalable manufacturing. ABSTRACT Perovskite solar cells (PSCs) are
Oluka Okia +9 more
wiley +1 more source
Experimental performance of water cooled building integrated photovoltaic/thermal solar collectors
, 2008 The idea of integrating water cooled photovoltaic/thermal collectors into building structures (BIPVT collectors) to provide electrical and heat energy is an area that has received only limited attention.
Carson, James K. +2 more
core
Shaping Carbon Nitrides for Advanced Macrostructures
Advanced Materials Technologies, EarlyView.This review examines how carbon nitride can be shaped through a range of printing and interfacial assembly methods. By bringing together additive manufacturing and liquid–liquid structuring concepts, carbon nitride is moving beyond its traditional powder‐based photocatalyst form toward digitally designed robust macroscale architectures with high design
Simona Baluchová, Baris Kumru
wiley +1 more source
Advanced Materials Technologies, EarlyView.Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta +4 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.The opto‐electronic response of polycrystalline (PEA)2PbBr4 thin films is investigated by correlating macroscopic photodetector performance with nanoscale mapping techniques. Grain boundary density is systematically tuned through crystallization control and linked to device responsivity.
Camilla Bordoni +10 more
wiley +1 more source
Possibility of Modeling of Solar Collectors Systems in Latvia
The aim of the work is to explore suitability of Latvian environment to the usage of solar collectors system. For the attainment of objective monotype house will be modeled, the house will be equipped with the combined solar heat system, which will be ...
Šipkovs, Pēteris, Migla, Lana
core