Results 1 to 10 of about 6,390 (262)
Experimental performance and economic analysis of finned solar receiver for parabolic dish solar collector [PDF]
The solar receiver is a vital component of concentrated solar collectors that absorbs solar radiation and converts it into heat. One of the challenges the research community faces is minimizing heat loss from the receiver at higher temperatures to ...
Senthil Kumar Vishnu, Ramalingam Senthil
doaj +2 more sources
Porous Carbon Nanofoam Derived From Pitch as Solar Receiver for Efficient Solar Steam Generation [PDF]
Photothermal‐material‐assisted solar‐steam generation has recently attracted intensive attention due to its superior evaporation rate with high energy conversion efficiency for desalination.
Lihua Chen +6 more
doaj +2 more sources
Thermal Performance Characteristics of a Microchannel Gas Heater for Solar Heating Applications
In the present article, the heat transfer and fluid flow of the air in a compact microchannel gas heater (MCGH) was experimentally quantified. To understand the effect of heat flux value (HFV), and inlet velocity on the heat transfer coefficient (HTC ...
Bo Yang +2 more
doaj +1 more source
Deflection and stresses in solar central receivers [PDF]
The aim of the design of central solar receivers is to withstand the high non-uniform solar-heat-flux and temperature during the solar-power-plant lifetime. This high non-uniform tube temperature causes high thermal stress, producing creep and fatigue damage.
Laporte Azcué, Marta +3 more
openaire +2 more sources
Using supercritical CO2 as a heat transfer fluid in microchannel receivers is a promising alternative for tower concentrating solar power plants. In this paper, the heat transfer and flow characteristics of supercritical CO2 in microchannels at high ...
Xiaoru Zhuang +4 more
doaj +1 more source
A novel approach for manufacturing porous materials, foreseen as solar receivers for concentrated sun radiation, used in the power tower technology is presented.
Fernando Almeida Costa Oliveira +6 more
doaj +1 more source
The absorber tubes are subjected to highly non-uniform solar irradiation inside a water/steam solar cavity receiver. This causes the uneven wall temperature and large gradients applied to the absorber tubes, producing thermal deformation and stress, even
Canghong ZHANG, Nan TU, Jiabin FANG
doaj +1 more source
A prototype rotary solar receiver and a solar simulator facility have been designed, built and commissioned by Odqa Renewable Energy Technologies in conjunction with The Oxford Thermofluids Institute, University of Oxford for the validation of ...
Pok-Wang Kwan +7 more
doaj +1 more source
Design and installation of (flower sun) a concentration dish and study its parameters
Design and installation of (3m) aperture concentration, by using Six curved pieces in the form of parabola Was covered by Aluminum golden mirror, the (focus) at (1.52 m) from the center of parabolic dish, a receiver (boiler) fixed at focus, the ...
Yaseen. H. Mahmood +2 more
doaj +1 more source
Characterization of Solar-Aged Porous Silicon Carbide for Concentrated Solar Power Receivers [PDF]
Porous silicon carbide is a promising material for ceramic receivers in next-generation concentrated solar power receivers. To investigate its tolerance to thermal shock, accelerated ageing of large coupons (50 × 50 × 5 mm) was conducted in a solar furnace to investigate the effects of thermal cycling up to 1000 °C, with gradients of up to 22 °C/mm ...
Cañadas, I +11 more
openaire +2 more sources

