Results 1 to 10 of about 142,443 (296)
Numerical Study on the Solid Fuel Rocket Scramjet Combustor with Cavity [PDF]
Energies, 2019 Scramjet based on solid propellant is a good supplement for the power device of future hypersonic vehicles. A new scramjet combustor configuration using solid fuel, namely, the solid fuel rocket scramjet (SFRSCRJ) combustor is proposed.
Chaolong Li +4 more
doaj +5 more sources
THERMAL PROTECTION SOLUTION FOR SOLID FUEL ROCKET ENGINES [PDF]
Advanced Engineering Letters, 2023 This paper presents a new approach to the thermal protection of solid-fuel rocket engines. The method of thermal protection using coatings not only reduces the risk of damage to the engine casing but also increases the engine’s efficiency in working ...
Nguyen Minh Phu +2 more
doaj +3 more sources
Designing, Modeling and Simulation of Solid Fuel Rocket ALP-01
European Journal of Science and Technology, 2019 In this study the design of solid-fuel low-altitude rocket ALP-01 CAD has been optimized for the selected engine of rocket sizes for an altitude of 1500 meters. Parabolic type was preferred as the cone geometry. The length is calculated as 35cm. 3D printer for nose cone and shoulder section will be prepared by hand and made from glass fiber by hand ...
Sezer Çoban
semanticscholar +7 more sources
Physics of aerodisperse systems, 2023 The causes of pressure pulsations in the combustion chamber of the solid-fuel booster of the "Arian-5" rocket have been hypothesized. The assumption is that the burning drops of red-hot aluminum are a source of thermal radiation, the radiation ...
V.S. Kozin
openalex +3 more sources
Global stratospheric effects of the alumina emissions by solid‐fueled rocket motors [PDF]
Journal of Geophysical Research: Atmospheres, 2001 We simulate accumulation of Al2O3 particles in the atmosphere produced by solid‐fueled rocket motors by using the Goddard Institute for Space Studies/University of California at Irvine three‐dimensional (3‐D) chemistry‐transport model (CTM). Our study differs from Jackman et al.
M. Y. Danilin +8 more
openalex +6 more sources
Journal of Mechanical Engineering and Sciences, 2021 The process of fused deposition material (FDM) was used to manufacture propellant grains of Acrylonitrile Butadiene Styrene (ABS) as novel rocket fuel grain, with three types of geometry in the burning port.
J. A. Urrego P. +2 more
doaj +2 more sources
High Temperature Materials and Processes, 2014 This communication presents thermal diffusivity measurements of fourteen layered insulating composite materials. Composite materials that were taken under investigation contained matrixes based on epoxy and phenol-formaldehyde resins and reinforcements ...
Dominiak Adam +4 more
doaj +2 more sources
Journal of Physical Mathematics & its Applications, 2023 The article is dedicated to the theoretical study of the non-stationary Combustion Velocity of Solid Rocket Fuel (CVSRF). To calculate the Internal Ballistic Characteristics (IBC) of solid fuel missile engines, combustion velocity laws are used.
E. В. Алвес, Manuel Joaquim Alves
openalex +2 more sources
ROCKET ENGINE ON GRANULAR SOLID FUEL
Perm National Research Polytechnic University Aerospace Engineering Bulletin, 2021 The paper is devoted to the development of a rocket engine on granular solid fuel (REGSF). The paper shows the main advantages and disadvantages of widely used propulsion systems (such as a solid-propellant rocket engine, liquid-propellant rocket engine,
Andrey Elkin +4 more
openalex +2 more sources
Amine-AlH<sub>3</sub> Adducts as Energetic Materials for a New Generation of Solid Fuels. [PDF]
ChemistryNew amine‐AlH₃ adducts offer a more environmentally friendly, high‐energy alternative to conventional rocket propellants, and exhibit ultra‐fast ignition. They can be synthesized by mechanochemical method under hydrogen pressure starting from aluminum metal directly or by wet chemical processes with AlH3.
Liu X +4 more
europepmc +2 more sources