Results 151 to 160 of about 426,283 (278)

The Influence of Solidification Rate on HightinBronze Microstructure

open access: yesArchives of Foundry Engineering, 2018
Bartocha, D., Baron, C., Suchoń, J.
openaire   +1 more source

2D Co‐Assembly of Solid Acids Enables Stable Superprotonic Conduction Above 260°C

open access: yesAdvanced Functional Materials, EarlyView.
A two‐dimensional co‐assembly strategy integrates antimony phosphate and phosphotungstic acid nanosheets into free‐standing inorganic lamellar membranes with confined acid–acid interfaces. The resulting interfacial hydrogen‐bond network enables anhydrous proton conductivity exceeding 0.1 S cm−1 at 260°C and supports stable high‐temperature fuel‐cell ...
Qiuning Li   +8 more
wiley   +1 more source

Bacterial Cellulose‐Based Bilayer Passive Cooler for High‐Performance Radiative/Evaporative Cooling

open access: yesAdvanced Functional Materials, EarlyView.
A sustainable bilayer passive cooler based on bacterial cellulose integrates radiative and evaporative cooling for efficient zero‐energy temperature reduction. The scalable, low‐carbon material shows strong potential for food preservation, low‐temperature storage, and cold‐chain logistics.
Yibing Zhang   +6 more
wiley   +1 more source

Gradient‐Conductivity Architecture Enables Synchronous Enhancement of Sensitivity and Detection Range in Multifunctional All‐Paper Sensors

open access: yesAdvanced Functional Materials, EarlyView.
A gradient‐engineered all‐paper sensor is fabricated by integrating MXene and in situ grown AgNPs within hierarchical cellulose networks. The device breaks the sensitivity–detection range trade‐off through cascaded conductive pathways, enabling ultrahigh pressure sensitivity, humidity–pressure decoupled dual‐mode sensing, and outstanding EMI shielding,
Ao Li   +7 more
wiley   +1 more source

Mechanical Programming of PEGDA‐β‐CD Polyrotaxane‐Based Hydrogels via Host–Guest Molecular Recognition

open access: yesAdvanced Functional Materials, EarlyView.
A mechanically programmable hydrogel for tissue engineering is developed by modulating the molecular threading density of poly(ethylene glycol) diacrylate‐β‐cyclodextrin (PEGDA‐β‐CD) polyrotaxane and combining it with β‐CD‐modified gelatin. The polyrotaxane‐guided transition from disordered pores to laminar microstructures enables precise tuning ...
Shiyi Chen   +10 more
wiley   +1 more source

Scandium Microalloying for Al-Cu-Mg-Mn-Ti Alloys with High Cu Content. [PDF]

open access: yesMaterials (Basel)
Guo J   +8 more
europepmc   +1 more source

Bone‐Inspired Recyclable Composites for Damage‐Tolerant Circular Materials

open access: yesAdvanced Functional Materials, EarlyView.
Bone‐inspired architected composites are developed by combining osteon‐like reinforcements with a recyclable Elium thermoplastic matrix. The hierarchical architecture redirects cracks and promotes energy dissipation, while enabling recovery of intact, aligned, load‐bearing reinforcement units that retain their original stiffness, revealing a route ...
Alessandro Stagni   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy