Results 81 to 90 of about 357,505 (313)
A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
This paper reports on the result of space charge evolution in cross-linked polyethylene (XLPE) planar samples of approximately 220 ?m thick. The space charge measurement technique used in this study is the PEA method.
Tanaka, Y +5 more
core
Impact of mechanical deformation on space charge in XLPE [PDF]
In this paper we report the effect of mechanical deformation on space charge dynamics in crosslinked polyethylene. Thin films were peeled from a 66 kV commercial XLPE cable. Space charge measurements under dc electric fields have been monitored using the
Kamaruzzaman, M. R. +3 more
core +1 more source
A hierarchical porous copper current collector is fabricated via three‐dimensional printing combined with pressureless sintering to stabilize lithium metal anodes. The interconnected architecture lowers local current density, guides uniform Li deposition within pores, and suppresses dendrite growth.
Alok Kumar Mishra, Mukul Shukla
wiley +1 more source
Space Charge Behavior in Ethylene Propylene Rubber Under a 50-Hz AC Electric Field
In this study, the space charge behavior in ethylene propylene rubber (EPR) under a 50-Hz AC field is studied based on the variation of space charge response, FTIR spectra and impurity contents inside EPR with thermal treatment.
Chang Dai +4 more
doaj +1 more source
Space charge measurement and analysis in low density polyethylene films
The growing requirement of reliability for an insulation system gives researchers greater responsibility to investigate new techniques for monitoring and diagnosing dielectrics subjected to an electric field.
Xu, Zhiqiang
core
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Inhibition Effect of Graphene on Space Charge Injection and Accumulation in Low-Density Polyethylene
Space charge injection and accumulation is attracting much attention in the field of dielectric insulation especially for electronic devices, power equipment and so on.
Zhonglei Li +4 more
doaj +1 more source
Space Charge Behaviour in LDPE after AC Ageing
Space charge accumulation after ac ageing and its effect on dc poling has been studied in low-density polyethylene (LDPE). LDPE film samples with thickness of around 180mm were aged at an electric stress of 50kV/mm under 50 Hz ac voltage for various ...
Liu, X, Fu, M, Chen, G
core
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source

