Results 111 to 120 of about 62,450 (242)
Spark plasma sintering enables rapid processing of porous organic polymer (POP) from fine powders to a freestanding and mechanically robust monolith. The sintering process retains the CO2 adsorption capacity and CO2/N2 selectivity, making the monolith more suitable as a solid sorbent for practical carbon capture applications.
Duan Li +4 more
wiley +1 more source
This research presents a novel implantable bio‐battery, GF‐OsG, tailored for diabetic bone repair. GF‐OsG generates microcurrents in high‐glucose conditions to enhance vascularization, shift macrophages to the M2 phenotype, and regulate immune responses.
Nanning Lv +10 more
wiley +1 more source
Xylan derived carbon sphere/graphene composite film with low resistance for supercapacitor electrode
Reduced graphene oxide (rGO) films suffer from low capacitance for inner unreduced oxygen functional groups, restacking of sheets and high contact resistance.
Jihai Cai +4 more
doaj +1 more source
Mg‐based thermoelectrics are among the most promising candidates for power generation applications but their performance is compromised by Mg loss at device operation temperatures due to the higher chemical potential of Mg (μMg${\mu}_{\mathrm{Mg}}$) inside the material compared to the environment.
Aryan Sankhla +2 more
wiley +1 more source
High Specific Capacitance of the Electrodeposited MnO2 on Porous Foam Nickel Soaked in Alcohol and its Dependence on Precursor Concentration. [PDF]
Zhang M +5 more
europepmc +1 more source
This work presents a continuous linear gradient catalyst layer design, a general strategy for improving membrane electrode assemblies across electrochemical devices. Fabricated via a dual‐nozzle spray coating method, the architecture controls the Pt/carbon ratio, ionomer content and ionomer type across the catalyst layer, enhancing proton conduction ...
Shangwei Zhou +15 more
wiley +1 more source
A roll‐to‐roll exfoliation method is demonstrated that preserves the crystallographic alignment of anisotropic 2D materials over large areas, enabling scalable fabrication of directional electronic and optoelectronic devices. Abstract Anisotropic 2D materials such as black phosphorus (BP), GeS or CrSBr, exhibit direction‐dependent optical and ...
Esteban Zamora‐Amo +14 more
wiley +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
Chloride and Salicylate Influence Prestin-dependent Specific Membrane Capacitance [PDF]
Joseph Santos-Sacchi, Lei Song
openaire +1 more source
Spectrally Tunable 2D Material‐Based Infrared Photodetectors for Intelligent Optoelectronics
Intelligent optoelectronics through spectral engineering of 2D material‐based infrared photodetectors. Abstract The evolution of intelligent optoelectronic systems is driven by artificial intelligence (AI). However, their practical realization hinges on the ability to dynamically capture and process optical signals across a broad infrared (IR) spectrum.
Junheon Ha +18 more
wiley +1 more source

