Results 1 to 10 of about 467 (168)
Effect of liquid surface tension coefficient on spray cone structure of ejection sprayer [PDF]
E3S Web of Conferences, 2023 The results of an experimental study of the effect of surfactants on the spatial distribution of droplet concentration in the spray cone of the ejective sprayer are presented.
Arkhipov Vladimir +3 more
doaj +1 more source
Numerical simulation of atomization and combustion characteristics of high-moisture organic wastewater [PDF]
E3S Web of Conferences, 2021 The combustion method, due to its convenience and high-efficiency in harmless treatment, has been widely used in disposal of wastewater. With a wastewater burner as the study case, we performed numerical simulation by the Fluent software, analyzed the ...
Ding Jing, Tang Qiang, Zhang Tengfei
doaj +1 more source
Scientific Reports, 2023 This work focuses on leveraging deep learning for agricultural applications, especially for spray pattern segmentation and spray cone angle estimation.
Praneel Acharya +2 more
doaj +1 more source
Application rate and nozzles associated with droplet electrification affect the spraying quality in common bean [PDF]
Revista Brasileira de Engenharia Agrícola e Ambiental, 2023 The objective of this work was to evaluate the application efficiency of different nozzle tips associated with increasing application rates. A field experiment was conducted in a factorial 3 × 4 randomized block design with four replicates.
Carlos E. L. Mello +7 more
doaj +1 more source
Effect of Low Ambient Pressure on Spray Cone Angle of Pressure Swirl Atomizer
International Journal of Aerospace Engineering, 2021 Pressure swirl atomizers are widely used in gas turbine combustor; this paper is aimed at researching the effect of low ambient pressure (0.1 MPa to 0.01 MPa, lower than an atmosphere) on the spray cone angle of pressure swirl atomizer.
Zhengyan Guo +7 more
doaj +1 more source
Entropy, 2022 The behaviors of spray, in Reactivity Controlled Combustion Ignition (RCCI) dual fuel engine and subsequent emissions formation, are numerically addressed.
Fathi Hamdi +6 more
doaj +1 more source
Frontiers in Chemistry, 2022 In this study, we systematically evaluated the factors affecting the ionization efficiency of paper spray ionization (PSI), such as electric field, solvent supply rate, and paper thickness and hydrophobicity. The observed paper spray plume was classified
Thi Minh Hoa Nguyen +2 more
doaj +1 more source
Experimental Study on Effect of Water Spray Characteristics on Performance of Cooling Tower [PDF]
E3S Web of Conferences, 2020 Cooling tower is an indispensable part, used as a direct contact type heat exchanger mainly for evaporative cooling. Cooling tower generally dissipates, remove heat from thermal power plants.
Dhurandhar Akshay S. +1 more
doaj +1 more source
Design and Analysis of Pressure- Swirl Fuel Injector with Full- Cone Spray for Catalytic Thruster [PDF]
علوم، فناوری و کاربردهای فضایی, 2022 The monopropellant thrusters of the situation control system are a requirement for the development and application of satellites and space capsules in space, which are high-tech and expensive. In this paper, the design and simulation of a pressure- swirl
Hadiseh Karimaei
doaj +1 more source
Research on the internal flow and macroscopic characteristics of a diesel fuel injection process.
PLoS ONE, 2021 The internal flow and macroscopic spray behaviors of a fuel injection process were studied with schlieren spray techniques and simulations. The injection pressures(Pin)and ambient pressures(Pout)were applied in a wide range.
Hua Xia
doaj +1 more source