Challenges and enablers in fluidization technology
Abstract Gas–solid fluidized beds provide excellent heat and mass transfer for high‐throughput operations from coating to catalytic conversion and underpin emerging low‐carbon technologies. Yet industrial reliability, scale‐up, and control lag scientific understanding, particularly as finer, stickier, and more variable feedstocks increasingly challenge
J. Ruud van Ommen, Jia Wei Chew
wiley +1 more source
Editorial for the Special Issue on Heat and Mass Transfer in Microchannels. [PDF]
Xiao X, Zhang X, Zhang L.
europepmc +1 more source
High‐elevation endemic plants predicted to lose habitat from changing climate in Washington State
Abstract Premise High‐elevation plants face unique challenges from potential climate change impacts that will likely require upslope migration into increasingly smaller suitable habitat. This situation is particularly acute for endemic species that by definition occupy small geographic ranges.
Nicholas L. Gjording +4 more
wiley +1 more source
An experimental investigation of the drift ratio and its influencing factors in mechanical draft wet cooling towers. [PDF]
Qu L, Li L.
europepmc +1 more source
Surface and intradermal temperature responses of adults to ambient heat stress with and without cooling. [PDF]
McKenna ZJ +5 more
europepmc +1 more source
Degradation Mechanisms, Encapsulation‐Based Stabilization, and Analytical Detection of Vitamin A
ABSTRACT Vitamin A is an important lipid‐soluble micronutrient essential for vision, immune function, and overall growth and development. However, vitamin A is unstable and susceptible to environmental factors because of its conjugated structure and inherent chemical reactivity.
Latheesha Abeywardana +5 more
wiley +1 more source
Fatigue behavior and translucency of lithium disilicate ceramic: effect of glazing application. [PDF]
Riesgo BVP +6 more
europepmc +1 more source
Material Characterization of Lignin‐Filled Polypropylene Composites
Ground and spray‐dried lignin powders are compared as fillers for polypropylene composites. Differences in powder preparation methods are associated with differences in powder characteristics and composite behavior after melt compounding. Spray‐dried lignin produces smaller particles and fewer large agglomerates, while a 5 wt% lignin loading provides a
Sungjun Hwang +3 more
wiley +1 more source
Clinical strategy to enhance cyclic fatigue resistance of Ni-Ti rotary files using refrigerant spray. [PDF]
Punnarai P +4 more
europepmc +1 more source
Objective Osteoarthritis, the leading cause of disability worldwide, disproportionately affects women, yet sex remains an overlooked determinant. This disparity stems from sex‐specific differences in injury susceptibility—a major risk factor for disease.
Hope D. Welhaven +6 more
wiley +1 more source

