Results 291 to 300 of about 2,242,769 (340)
Some of the next articles are maybe not open access.
Water spray cooling of polymers
Polymer Engineering & Science, 2011AbstractThe cooling process in conventional rotomolding is relatively long due to poor thermal conductivity of plastics. The lack of internal cooling is a major limitation although rapid external cooling is possible. Various internal cooling methodologies have been studied to reduce the cycle time.
Tan, S.B. +4 more
openaire +2 more sources
Modeling of a PV system by a back-mounted spray cooling section for performance improvement
Applied Energy, 2023Qi Zhang +11 more
semanticscholar +1 more source
, 2020
Today, performance of lithium-ion battery is still limited by its operating temperature. The upper bound is capped by 50 ∘C. However, this limit is easily surpassed if batteries work at a high room temperature.
S. Lei, Yong-Lin Shi, Guan-Yi Chen
semanticscholar +1 more source
Today, performance of lithium-ion battery is still limited by its operating temperature. The upper bound is capped by 50 ∘C. However, this limit is easily surpassed if batteries work at a high room temperature.
S. Lei, Yong-Lin Shi, Guan-Yi Chen
semanticscholar +1 more source
Effect of the spray cone angle in the spray cooling with R134a
Experimental Thermal and Fluid Science, 2013Spray cooling experiments were performed to study the effect of the spray cone angle on heat transfer and film thickness. The experiments were carried out for three different types of nozzles. Results for heat transfer and film thickness for different flow rates are presented working with the dielectric refrigerant R134a and on a heater with low ...
Eduardo Martínez-Galván +3 more
openaire +1 more source
Thermal characteristics and effects of oil spray cooling on in-wheel motors in electric vehicles
Applied Thermal Engineering, 2019The output, efficiency, and durability of in-wheel motors in electric vehicles (EVs) depend on heat dissipation performance; therefore, effective active cooling is essential.
M. Park, Sung Chul Kim
semanticscholar +1 more source
Effect of spray characteristics on spray cooling with liquid nitrogen
Journal of Thermophysics and Heat Transfer, 1994Operation of power electronics at liquid nitrogen (LN2) temperature is a very attractive possibility. However, a high heat flux (over 100 W/cm) cooling technique like spray cooling will have to be used to realize all the advantages of low-temperature operation. This study provides empirical correlations for LN2 spray cooling.
Maninder Sehmbey +3 more
openaire +1 more source
International Journal of Heat and Mass Transfer, 2019
Flash spray cooling has been considered as one of the most promising technologies of heat dissipation for high power electronic devices because of its high cooling capacity at low surface temperature.
Zhi-Fu Zhou +5 more
semanticscholar +1 more source
Flash spray cooling has been considered as one of the most promising technologies of heat dissipation for high power electronic devices because of its high cooling capacity at low surface temperature.
Zhi-Fu Zhou +5 more
semanticscholar +1 more source
Application status and prospect of spray cooling in electronics and energy conversion industries
Sustainable Energy Technologies and Assessments, 2022Hua Chen +4 more
semanticscholar +1 more source
Building and Environment, 2022
Meng Xi, Meng Li, Gao-Wen Yi, Haoran Li
semanticscholar +1 more source
Meng Xi, Meng Li, Gao-Wen Yi, Haoran Li
semanticscholar +1 more source

