Results 21 to 30 of about 48,041 (259)
Simulation of Atomization Gas Flow Field During Constrained Spray Deposition Process
Cailiao gongcheng, 2018 Double disks controller was used to constrain the size of spray plume. The flow field characteristics of the constrained spray technology under different gas inlet pressures were simulated by the computational fluid dynamics (CFD) software "Fluent", and ...
YIN Jian-cheng +5 more
doaj +1 more source
Metals, 2020 The lightweight Fe−Mn−Al−C steels have drawn considerable attention from the literature due to their outstanding combination of high ductility and specific strength.
Lucas Otani +6 more
doaj +1 more source
Revista de Metalurgia, 2000 En este trabajo se ofrece una revisión de los distintos métodos de conformado y consolidación de materiales compuestos de matriz metálica reforzados con partículas.
Cesar Edil da Costa +2 more
doaj +1 more source
Mucoadhesive Film Forming Spray for Buccal Drug Delivery: A Review
Al-Mustansiriyah Journal of Pharmaceutical Sciences, 2023 Film-forming sprays provide a number of advantages over conventional topical treatments, including equal medication distribution and dosing, increased bioavailability (increase local drug concentration), and less irritability (Dosing frequency ...
Reem Wael Shahadha +1 more
doaj +1 more source
Cold spray forming of Inconel 718
, 2013 Inconel 718 was cold spray formed to a 6-mm thickness on an 8-cm diameter aluminum alloy tube using Sulzer Amdry 1718 powder and the Plasma Giken PCS-1000 cold spray system.
Wong, W. +7 more
core +1 more source
Microstructure and wear resistance of spray-formed M3 high speed steel with niobium addition
工程科学学报, 2015 M3 high speed steel (HSS) with or without niobium addition was prepared by spray forming, and the effect of niobium on the microstructure of M3 HSS was investigated by scanning electron microscopy (SEM) combined with energy dispersive X-ray (EDX ...
WANG He-bin +6 more
doaj +1 more source
, 1995 Spray forming is a relatively new manufacturing process for near net shape preforms in a wide variety of alloys. Spray formed materials have a characteristic equiaxed microstructure with small grain sizes, low levels of solute partitioning, and inhibited
GRANT, Patrick
core +1 more source
Gas Atomization of Aluminium Melts: Comparison of Analytical Models
Metals, 2012 A number of analytical models predicting the size distribution of particles during atomization of Al-based alloys by N2, He and Ar gases were compared.
Georgios Antipas
doaj +1 more source
Crystallographic orientation-spray formed hypereutectic aluminium-silicon alloys
Materials Research, 2005 Aluminium-silicon alloys have been wide accepted in the automotive, electric and aerospace industries. Preferred orientation is a very common condition for metals and alloys. Particularly, aluminium induces texture during the forming process.
Hamilta de Oliveira Santos +4 more
doaj +1 more source
Hyperosmotic stress induces PARP1‐mediated HPF1‐dependent mono(ADP‐ribosyl)ation
FEBS Letters, EarlyView.Sorbitol‐induced hyperosmotic stress rapidly induces reversible mono(ADP‐ribosyl)ation (MARylation) on PARP1 without the signs of genotoxic signaling. We show that PARP1 autoMARylation is HPF1 dependent and forms hydroxylamine‐resistant O‐glycosidic linkages.
Anna Georgina Kopasz +11 more
wiley +1 more source