Results 61 to 70 of about 195,216 (287)
Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites
Advanced Materials Technologies, EarlyView.Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang +9 more
wiley +1 more source
Spray distribution uniformity of different types of nozzles and its spray deposition in potato plant
, 2011 Spray distribution uniformity on sampling posts and spray deposition in potato plants were investigated with six different types of spray nozzles (standard flat fan, hollow cone, air induction and twin jet hydraulic nozzles, spinning disc nozzle and air ...
Bastaban, Saim, Sayinci, Bahadir
core +2 more sources
Spray Notice of Adopted Amendment (2012-02-21)
, 2012 13 pp. Adopted 2012-02-21. Department of Land Conservation and Development Notice of Adopted AmendmentThe annexation of the territory is consistent with the fundamental principals and adopted City policies and it is in the best interest of the City that ...
Spray (Or.)
core +1 more source
Diagnostics of water sprays for cooling suction air of gas turbine
Nihon Kikai Gakkai ronbunshu, 2017 Water spray is used for cooling suction air of gas turbine for power augmentation. Cooling efficiency depends on the spraying properties. The aim of this study is to investigate the spray characteristics and the influence of secular change in the spray ...
Keitaro MOTOI +4 more
doaj +1 more source
Advanced Manufacturing of Composite‐Based Systems for Energy Applications
Advanced Materials Technologies, EarlyView.Advanced manufacturing enables the integration of polymers, ceramics, metal oxides, and composites into architected microstructures with tailored transport pathways. By coupling material selection, manufacturing strategy, and structural design, multifunctional energy systems can simultaneously improve electrochemical performance, thermal management ...
Sri Vaishnavi Thummalapalli +13 more
wiley +1 more source
This is a correction due to errors in the evaluation of the validity of the tests of the data set publication: Ahrens, K., Herbst, A., & Wegener, J. K. (2025).
Herbst, Andreas +2 more
core +1 more source
COLD FLOW TESTING OF DUAL-BELL NOZZLES IN ALTITUDE SIMULATION CHAMBERS [PDF]
, 2005 DLR studied various subscale cold flow dual-bell nozzles at test facility P6.2. To fulfill future test requirements the facilitywas modified.
Böhm, Christian +3 more
core
Experimental and numerical study of heat flux in dual bell nozzles [PDF]
, 2011 The characteristic contour inflection of a dual bell nozzle is the key to altitude adaption. In sea level conditions, it forces the flow to a symmetrical separation, limiting the side load generation and increasing the thrust.
Gernoth, Andreas +5 more
core +1 more source
High Throughput Aerosol Jet Printing to Operationalize High Aspect Ratio Patterning
Advanced Materials Technologies, EarlyView.High‐throughput aerosol jet printing poses distinct limiting mechanisms to the printing process. These include rapidly changing ink chemistries, atomization instabilities, and liquid‐phase spreading. The combination of in‐line heating, process monitoring, and traditional optimization procedures enables rapid printing of high‐aspect‐ratio structures ...
Bella I. Guyll +4 more
wiley +1 more source
Properties analysis of the spray nozzles in drying plant
, 2015 The process of evaporating liquid inside a material is called drying. In the technical sense, drying is a process in which humidity is released from the material by external intervention using various methods.
Yildirim B., Sahin M., Misirli C.
core +3 more sources