Results 11 to 20 of about 23,091 (262)
BIOBIESEL FUEL SPRAY PENETRATION MODELLING
Dvigateli vnutrennego sgoraniâ, 2015 A model for biodiesel spray penetration under conditions relevant to internal combustion engines is suggested. A parameter referred to as “length parameter” is introduced to define the fuel properties.
Ruslana Vitaliyivna Kolodnytska
doaj +2 more sources
Spray characteristics of supercritical DME
Nihon Kikai Gakkai ronbunshu, 2020 The penetration of DME spray is shorter than that of diesel fuel when the same injection system is used because DME cannot be injected at high pressure like diesel fuel due to its high compressibility. Chris reported that supercritical gasoline spray has
Ryuhei TAKADA +6 more
doaj +1 more source
Energies, 2015 The objective of this study was to investigate the macroscopic spray characteristics of different 0%–100% blends of biodiesel derived from drainage oil and diesel (BD0, BD20, BD50, BD80, BD100), such as spray tip penetration, average tip velocity at ...
Hongzhan Xie +5 more
doaj +1 more source
First Study on Ammonia Spray Characteristics with a Current GDI Engine Injector
Fuels, 2021 Using carbon free energy sources is one of the keys to mitigate climate change. Hydrogen promises to be one of these carbon free energies, but its storage is difficult and expensive.
Ronan Pelé +4 more
doaj +1 more source
Research on the internal flow and macroscopic characteristics of a diesel fuel injection process.
PLoS ONE, 2021 The internal flow and macroscopic spray behaviors of a fuel injection process were studied with schlieren spray techniques and simulations. The injection pressures(Pin)and ambient pressures(Pout)were applied in a wide range.
Hua Xia
doaj +1 more source
Liquid Propane Injection in Flash-Boiling Conditions
Energies, 2021 This study aimed to investigate the influence of flash-boiling conditions on liquid propane sprays formed by a multi-hole injector at various injection pressures.
Łukasz Jan Kapusta +5 more
doaj +1 more source
Energy Reports, 2021 Air-assisted fuel injection (AAFI) systems may be installed in aviation piston engines for atomization of heavy fuels. However, there are few studies on the in-cylinder air-assisted spray characteristics, which affects the improvement of AAFI engine ...
Bingxuan Du, Zhenfeng Zhao
doaj +1 more source
Oil & Gas Science and Technology, 2010 The purpose of this study is the experimental investigation of Soybean oil Methyl Ester (SME) and DiMethyl Ether (DME) spray characteristics injected through the common-rail injection system under various ambient pressures. A high pressure chamber that
Kim H.J., Park S.H., Chon M.S., Lee C.S.
doaj +1 more source
Agronomy, 2022 Efficient utilization is a pre-requisite for pesticide reduction, and appropriate airflow distribution pattern plays a key role in enhancing the effectiveness of pesticide application by air-assisted orchard sprayers, yet the mechanism of this is unclear.
Tian Li +6 more
doaj +1 more source
Temporal Evolution of Split-Injected Fuel Spray at Elevated Chamber Pressures
Energies, 2019 For reducing soot and NOx emissions, an effective method is to apply split injection strategies. In this research, characteristics of split injection were investigated by applying the pilot-main injection strategy and main-post injection strategy.
Gang Wu, Xinyi Zhou, Tie Li
doaj +1 more source