Results 21 to 30 of about 40,525 (255)
EPJ Photovoltaics, 2021 Numerical simulations of AZO/Zn1−xGexO/Cu2O solar cell are performed in order to model for the first time the impact of the germanium composition of the ZnGeO buffer layer on the photovoltaic conversion efficiency.
Chevallier Christyves +3 more
doaj +1 more source
SYNTHESIS AND CHARACTERIZATION OF TRANSPARENT PHOTOCATALYTIC ZTO COATINGS [PDF]
Advanced Engineering Letters, 2023 The photocatalytic approach is known to be one of the most promising processes for the tertiary treatment of polluted water. The paper presents studies of Zn2SnO4 (ZTO) coatings synthesized by spray pyrolysis of Zn and Sn salt solution with the ...
Alexander Akulinkin +2 more
doaj +1 more source
Energies, 2021 Noble metal-TiO2 nanohybrids, NM0-TiO2, (NM0 = Pt0, Pd0, Au0, Ag0) have been engineered by One-Nozzle Flame Spray Pyrolysis (ON-FSP) and Double-Nozzle Flame Spray Pyrolysis (DN-FSP), by controlling the method of noble metal deposition to the TiO2 matrix.
Maria Solakidou +2 more
doaj +1 more source
International Journal of Technology, 2020 Rough-surfaced nanocone structures are preferred for use as transparent conductive oxides due to their high optical transparency and electrical conductivity.
Sameera Attanayake +2 more
doaj +1 more source
Influence of diesel surrogates on the behavior of simplified spray models [PDF]
, 2012 Numerous experimental investigations make use of diesel surrogates to make the computational time reasonable. In the few studies where measured (surrogate and real diesel) and computed (surrogate only) results have been compared, the selection ...
F Battin-Leclerc +6 more
core +2 more sources
Spray pyrolysis deposited multiferroic BiFeO3 films [PDF]
Journal of Applied Physics, 2009 BiFeO 3 (BFO) films were prepared by nebulized spray pyrolysis technique on a single crystal LaAlO3 (001) substrate at ∼300 °C and annealing in oxygen at ∼550 °C for 1 h. In all films BFO is the majority phase having a rhombohedrally distorted structure with R3m symmetry and lattice parameters are a=3.96 Å and α=89.7°.
P. K. Siwach +4 more
openaire +1 more source
Growth of β-NaGaO2 thin films using ultrasonic spray pyrolysis
Journal of Asian Ceramic Societies, 2022 β-NaGaO2 thin films used as a precursor for thin films of β-CuGaO2, which is a safe and environment-friendly thin-film solar cell material, are grown using the ultrasonic spray pyrolysis technique employing precursor aqueous solutions dissolving oxide ...
Issei Suzuki +4 more
doaj +1 more source
Nature of Nitrogen Incorporation in BiVO4 Photoanodes through Chemical and Physical Methods [PDF]
, 2019 In recent years, BiVO4 has been optimized as a photoanode material to produce photocurrent densities close to its theoretical maximum under AM1.5 solar illumination. Its performance is, therefore, limited by its 2.4 eV bandgap.
Abdi, Fatwa F. +14 more
core +1 more source
Fabrication of oxidized CuO and spray-pyrolyzed TiO2 heterojunction thin film
Results in Physics, 2019 A heterojunction device was fabricated via oxidation of a thin film and spray pyrolysis. In this work, a copper oxide (CuO) film was grown via magnetron sputtering of Cu film deposited on pre-cut glass substrates and subsequent oxidation at 450 °C in air.
Rozen Grace B. Madera +2 more
doaj +1 more source
APL Materials, 2020 Spray pyrolysis is a convenient method for fabricating BiVO4 photoanondes from a precursor solution. As the precursor solution of spray pyrolysis can significantly influence the nanostructure and the amount of oxygen vacancies of the final films ...
Xi Chen +7 more
doaj +1 more source