Results 101 to 110 of about 4,097 (222)
MetalsSpringback control is a critical factor in profile stretch-bending-torsion forming. A new stretch-bending-torsion automatic forming method based on the mixture of finite element and BP neural network (FE-BPNN) is proposed.
Yu Wen, Jicai Liang, Yi Li, Ce Liang
doaj +1 more source
, 2005 During his introduction, Richard Baker described how, while Deputy Head of the Conservation Bindery of the Johns Hopkins University Library\u27he was introduced to the springback binding.
Verheyen, Peter D
core
Modeling Springback in Stamped Automotive Structures
, 2010 In sheet metal forming, the discrepancy between the fully loaded shape at the end of forming stage and the unloaded configuration is called springback. Springback is a major factor in preventing accurate dimensions of final products.
Ghaei, Abbas
core
Influence of Friction on Springback of Quadrangle Parts Bending
, 2011 Springback is the prominent problem in bending forming of sheet metal, which is difficult to control accurately, especially for the complex shaped bending parts.
Rui Ma +4 more
core +1 more source
Springback Force Considerations in Compliant Haptic Interfaces [PDF]
, 2015 This thesis investigates the potential benefits and challenges of using compliant mechanisms in the design of haptic interfaces. The benefits and challenges are presented with an emphasis on their inherent springback behavior and an active compensation ...
Swiss, Dallin R.
core
Analytical springback assessment in flexible stretch bending of complex shapes
, 2020 Stretch bending is commonly used in the fabrication of profile-based shapes. However, one of the challenges in many bending-type forming processes is controlling springback upon unloading.
Ma, Jun, Welo, Torgeir
core
Prediction of springback in sheet metal forming
, 2011 The prediction of springback is probably the area in sheet metal forming simulation, where the least success has been achieved in terms solution accuracy.
Eggertsen, Per-Anders
core
Springback prediction of thick-walled high-strength titanium tube bending
, 2013 Significant springback occurs after tube rotary-draw-bending (RDB), especially for a high-strength Ti–3Al–2.5V tube (HSTT) due to its high ratio of yield strength to Young’s modulus. The combination scheme of explicit and implicit is preferred to predict
Li, Guangjun +4 more
core +1 more source
Springback simulation in metal sheet forming
, 2022 S.134-144Springback prediction is an important issue for the sheet metal forming industry. The application of new materials, including high strength steel, for light weight structures in the automotive industry is often impeded by the insufficient ...
Andrieux, F. +4 more
core
Effect of Pre-Tension and Orientation on the Springback Behavior of the Sheet Brass 65-35
Al-Khawarizmi Engineering Journal, 2019 One of the most important phenomenon that occurs in sheet metal forming processes is the spring-back, which causes several geometrical alterations in the parts.
Aseel Hamad Abed, Anwar Hassan Zaboon
doaj