Results 181 to 190 of about 64,227 (310)

Power electronic configuration for the operation of PV system in combined grid‐connected and stand‐alone modes [PDF]

, 2013
S. Krithiga, Nanjappa Gounder Ammasai Gounden   +1 more
openalex   +1 more source

Political economy of primary health care resilience in Latin America and the Caribbean: insights from the WB/PAHO Commission recommendations. [PDF]

Lancet Reg Health Am
Báscolo E, Houghton N, Bennett S.
europepmc   +1 more source

3D‐Printed Architected Material for the Generation of Foam‐Based Protective Equipment

Advanced Engineering Materials, EarlyView.
This study investigates 3D‐printed architected structures as alternatives to traditional foams in protective gear. It focuses on customizing impact strength and damping through design and manufacturing integration. Testing shows these structures outperform conventional foams, offering enhanced customizability, lower weight, and tunable performance ...
Ali Zolfagharian, Gerard Bel Català, Daniel Saakes, Bernard Rolfe, Ian Gibson, Mehrshad Mehrpouya   +5 more
wiley   +1 more source

Optimizing the dynamic treatment regime of outpatient rehabilitation in patients with knee osteoarthritis using reinforcement learning. [PDF]

J Neuroeng Rehabil
Liu S, Luo J, He C.
europepmc   +1 more source

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

Advanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk, Marcin Michałowski, Bogdan Warcholiński, Michał Milczarek, Adam Gilewicz   +4 more
wiley   +1 more source

Smart control and management for a renewable energy based stand-alone hybrid system. [PDF]

Sci Rep
Kechida A, Gozim D, Toual B, Alharthi MM, Agajie TF, Ghoneim SMS, Ghaly RNR.   +6 more
europepmc   +1 more source

Subgrain and Cavity Development during Creep of Al‐3.85%Mg

Advanced Engineering Materials, EarlyView.
Al‐3.85%Mg does form subgrains if crept at very high strains. This fact allows the unification of the creep description in two different alloys such as pure Al and Al–Mg alloys. It is classically considered that the creep mechanisms for type M (e.g., pure Al) and type A alloys (e.g., Al–Mg alloys) are different.
Augusta Isaac, Itziar Serrano‐Munoz, Aleksander Kostka, Martinus Putra Widjaja, Gaspar González‐Doncel, Giovanni Bruno, Ricardo Fernández   +6 more
wiley   +1 more source

Low-cost, open-source device for applying controlled olfactory stimuli during functional magnetic resonance imaging (fMRI) of the brain. [PDF]

HardwareX
Salama R, Rodríguez-Lázaro MA, Castelo-Branco C, Herrero-Vidaurre I, Ribera-Torres L, Muñoz-Moreno E, Otero J, Farré R.   +7 more
europepmc   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

Advanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen, Benjamin Bohne, Sven Winter, Marcus Böhme, Martin F.-X. Wagner   +4 more
wiley   +1 more source

Association between simplified anthropometric age and functional performance metrics in older Chinese adults: A study on muscle strength, sit-to-stand ability, and gait speed. [PDF]

BMC Geriatr
Pu J, Jiang H, Wu J, Liu Y, Xu M, Tang Y, Tan Y, Wang Y.   +7 more
europepmc   +1 more source