Results 291 to 300 of about 1,286,748 (345)
Some of the next articles are maybe not open access.
Controlling a stand-alone power system
International Symposium on Power Electronics, Electrical Drives, Automation and Motion, 2006. SPEEDAM 2006., 2006This paper deals with a hybrid power system based on renewable energy sources, working in stand-alone mode. It consists of a micro-hydro plant including a synchronous generator and a wind turbine with an induction generator. A frequency controller, based on dump load and common voltage regulator for the two generators, ensures the system's power ...
C. Marinescu +4 more
openaire +1 more source
Stand-Alone Renewable Hybrid Power Generation System
2012 IEEE Global Humanitarian Technology Conference, 2012This paper presents the proposed design of a compact stand-alone hybrid power generation system using wind-solar resources. This system can be implemented in national highways where wind can be collected due to the high speed motion of vehicles and at the same time the solar energy from the ambient will also be collected.
P. Freddy Simon +2 more
openaire +1 more source
Stand-Alone Power Systems with IGBT Inverter
Applied Mechanics and Materials, 2015This article is an overview of research in fault diagnosis, detection, and reconfiguration. The review particularly focuses on power electronic applications and drives. Diagnostics of systems with conventional inverter drives (CID) is considered because knowledge of fault diagnosis in CIDs can be used for application in other inverter drive topologies;
Vadim Markovski +2 more
openaire +1 more source
Innovative solutions for stand alone system powering
INTELEC 07 - 29th International Telecommunications Energy Conference, 2007In the paper, possible hybrid configurations of low power stand alone systems based on renewable energy sources (RES) and alternative sources, suitable for applications in remote areas not connected to the grid such as radio base stations for mobile phone communications, are described and compared. As practical case, different alternative solutions for
BOCCALETTI, Chiara +2 more
openaire +2 more sources
Developing of Stand-Alone Power System Simulation Model
International Review of Automatic Control (IREACO), 2014In last two decades, the importance of stand-alone power systems has increased. No matter, if the system is a small mobile application like a smart phone or a large stand-alone house system, a simple simulation can be used for power flow control proposal. A simple power system supplied by photovoltaic module is proposed in this paper.
Martin Galád +2 more
openaire +1 more source
Stand-Alone Wind Power System with Improved Light-Power Efficiency
2020 IEEE Energy Conversion Congress and Exposition (ECCE), 2020A new interleaved buck converter is proposed in this paper to improve the performance of the battery charger of a stand-alone wind turbine. The converter uses just a single active auxiliary circuit to assist all the main converter switches operate with ZCS and operates with ZCS itself. This circuit does not increase the peak voltage or current stresses
Ramtin Rasoulinezhad +3 more
openaire +1 more source
Stand-Alone Photovoltaic Power System applications in Malaysia
2010 4th International Power Engineering and Optimization Conference (PEOCO), 2010This paper presents an overview and status Stand-Alone Photovoltaic Power System (SAPVPS) in Malaysia. Malaysia is located at equatorial line is suitable to generate a power supply from solar. Electrification of remote area in Malaysia shows progress in terms of capacity of SAPVPS installation.
Noridzuan Idris +2 more
openaire +1 more source
Stand-alone, FCG-driven High Power Microwave system
2009 IEEE Pulsed Power Conference, 2009An explosively driven High Power Microwave (HPM) source has been developed that is based on the use of a Flux Compression Generator (FCG) as the primary driver. Four main components comprise the HPM system, and include a capacitor-based seed energy source, a dual-staged FCG, a power conditioning unit and an HPM diode (reflex-triode vircator).
A. Young +6 more
openaire +1 more source
Flywheel‐based AC cache power for stand‐alone power systems
IEEJ Transactions on Electrical and Electronic Engineering, 2013AbstractStand‐alone power systems (SPS) are attracting more and more interest with the global move toward distributed generation (DG). Without strong support from the power grid, they suffer from poor load‐following capability at varying loads. A cache power that has fast response and high energy efficiency is demanded.
Miao‐Miao Cheng +3 more
openaire +1 more source