Results 1 to 10 of about 121,900 (274)
Reliability Comparative Evaluation of Active Redundancy vs. Standby Redundancy [PDF]
International Journal of Mathematical, Engineering and Management Sciences, 2016 Redundancy is a commonly applied reliability improvement technique to enhance the system reliability and availability of safety critical systems, or operational impact systems in the railroad and mass transit industry.
James Li
doaj +2 more sources
An Adjusted Water Cycle Algorithm for Solving Reliability-redundancy Allocation Problems with Cold-standby Components [PDF]
International Journal of Supply and Operations Management, 2018 Reliability-redundancy allocation problem (RRAP) is one of the most practical methods used to improve system reliability through performing a tradeoff between reliability and redundancy levels of components.
Mohammad N. Juybari +2 more
doaj +3 more sources
Research on resilience assessment method of train control on-board system [PDF]
HeliyonTo address the problem of difficult performance assessment of train control on-board system after recovery from failures, we have proposed a resilience assessment methodology that uses reliability as an indicator of system resilience.
Jinping Qi +5 more
doaj +2 more sources
Cold-standby redundancy allocation problem with degrading components [PDF]
International Journal of General Systems, 2015 Components in cold-standby state are usually assumed to be as good as new when they are activated. However, even in a standby environment, the components will suffer from performance degradation. This article presents a study of a redundancy allocation problem (RAP) for cold-standby systems with degrading components.
Junlin Xiong, Min Xie
exaly +3 more sources
Optimization Methods for Redundancy Allocation in Large Systems [PDF]
Vietnam Journal of Computer Science, 2020 This paper addresses the issue of optimal allocation of spare modules in large series-redundant systems in order to obtain a required reliability under cost constraints. Both cases of active and standby redundancy are considered.
Florin Leon +2 more
doaj +1 more source
Optimization Methods for Redundancy Allocation in Hybrid Structure Large Binary Systems
Mathematics, 2022 This paper addresses the issue of optimal redundancy allocation in hybrid structure large binary systems. Two aspects of optimization are considered: (1) maximizing the reliability of the system under the cost constraint, and (2) obtaining the necessary ...
Petru Cașcaval, Florin Leon
doaj +1 more source
Reliability Importance of Components in a Real-Time Computing System with Standby Redundancy Schemes [PDF]
International Journal of Mathematical, Engineering and Management Sciences, 2018 Component importance analysis is to measure the effect on system reliability of component reliabilities, and is used to the system design from the reliability point of view. On the other hand, to guarantee high reliability of real-time computing systems,
Junjun Zheng +2 more
doaj +1 more source
Mathematics, 2022 This study attempts to propose an availability optimization decision support design system for repairable n-stage mixed systems, in which different combinations of subsystems, such as parallel, standby, and k-out-of-q, are connected in series ...
Gia-Shie Liu, Kuo-Ping Lin
doaj +1 more source
Mathematics, 2023 In the present work, we study the combined m-consecutive-k-out-of-n: F and kc-out-of-n: F reliability systems, which consist of independent and identically distributed components.
Ioannis S. Triantafyllou
doaj +1 more source
Redundancy Allocation of Components with Time-Dependent Failure Rates
Mathematics, 2023 The Redundancy Allocation Problem (RAP) is well-known in the field of reliability optimization. In this paper, RAP is investigated assuming that the distribution of the time to failure of the components has the form of an Erlang distribution with a time ...
Enrico Zio, Hadi Gholinezhad
doaj +1 more source