Results 1 to 10 of about 402,416 (268)
Application research on 5G technology in fatigue test of full-scale aircraft
Hangkong gongcheng jinzhan, 2023 With the development of aircraft demand, and emerging of new material and new process, the test and validation technology of aircraft structure strength will also face new challenges.
LIU Bing, ZHANG Jianfeng, MU Bin
doaj +1 more source
Analysis of static response of RC beams with NSM CFRP/GFRP rods
Fracture and Structural Integrity, 2021 In this paper experimental results of investigation on reinforced concrete (RC) beams strengthened with the near surface method (NSM) are analyzed considering the response under bending tests on two beams. One of the RC beams was damaged by bending until
R. Capozucca +2 more
doaj +1 more source
The Removal of Selected Pharmaceuticals from Water by Adsorption with Granular Activated Carbons
Engineering Proceedings, 2023 The article deals with the removal of 20 selected drugs from drinking water by sorption on granulated activated carbon. Two different sorption materials were used, and the efficiency of removing these micropollutants was compared.
Ján Ilavský, Danka Barloková
doaj +1 more source
Multi-joint and Large Load Wing Load Processing Method
Hangkong gongcheng jinzhan, 2020 For test piece lacking the right outer wing portion, the many and complicated butt joints, and the large test load, will bring great difficulty to the application of the wing load. Therefore the independent loading clamp is designed for the three sets of
WANG Xintao, XIA Long, LIU Xingke
doaj +1 more source
Evaluation of the static and multistage geocell pullout behavior in coarse grained soil [PDF]
مهندسی عمران شریف, 2022 Geocell mattresses are one type of three-dimensional honeycomb soil reinforcements that is manufactured from polyethylene sheets using ultrasonically welded joints.
A. Namaei-kohal +2 more
doaj +1 more source
Determination of dynamic and static modulus of elasticity of beech plywood
Les, 2020 The study compared the values of the dynamic and static modulus of elasticity of 7- and 11-layer plywood with different combinations of the grain orientation of individual veneer layers.
Miran Merhar
doaj +1 more source
Hangkong gongcheng jinzhan, 2019 Nowadays, the mean load spectra is mostly used in fatigue test for aircraft, but it has the defects of long fatigue cycle. The severe load spectra is used instead, which can shorten the test time greatly. In order to meet the demand of full-scale fatigue
Zhang Jiajia, Jiang Zuguo, Feng Jianmin
doaj +1 more source
Applied Sciences, 2022 Railway sleepers are an important component of track systems, which can be manufactured by timber, concrete, steel and any other engineered materials. They serve as rail supports and transfer loads from trains to substructures of track systems.
Dan Li, Ruilin You, Sakdirat Kaewunruen
doaj +1 more source
Application of Concurrent Test Management Technique in Full Civil Aircraft Fatigue Test
Hangkong gongcheng jinzhan, 2019 Full aircraft structure fatigue test, as a part of civil aircraft structure airworthiness verification test, is the most complicated, the most expensive and the most time-consuming.
Xia Feng, Mu Shanshan
doaj +1 more source
Slovak Journal of Civil Engineering, 2020 In this paper, the short-term behavior of a new partially pre-cast and partially encased composite (PPEC) beam is studied. This paper reports the results of a 4-point bending test on a full-scale PPEC beam and sets out the load displacement response ...
Zhang Liufeng, Yang Yinghua
doaj +1 more source