Results 161 to 170 of about 4,554 (306)
Reactive power planning based on a proposed voltage stability index in power systems with renewable energy resources. [PDF]
Sonbol M +3 more
europepmc +1 more source
Multi‐Scale Interface Engineering of MXenes for Multifunctional Sensory Systems
MXenes, as two‐dimensional transition metal carbides and nitrides, demonstrate remarkable capabilities for multifunctional sensing applications. This review systematically examines multi‐scale interface engineering approaches that enhance sensing performance, enable diverse detection functionalities, and improve system‐level compatibility in MXene ...
Jiaying Liao, Sin‐Yi Pang, Jianhua Hao
wiley +1 more source
Advancing energy integration: renewable sources, ancillary services, and stability. [PDF]
Gulraiz A +2 more
europepmc +1 more source
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
Research on wind power penetration limit considering voltage stability. [PDF]
Liu X, Zhang Y, Li H, Zu W.
europepmc +1 more source
Efficient two‐photon resonant Raman scattering (TRRS) is observed in the layered perovskite (PEA)2PbI4, with the biexciton level acting as an intermediate state. TRRS undergoes two‐photon frequency shift upon input frequency tuning, persists up to 90 K, and shows clear threshold behavior and polarization selection rules.
Seung Han Shin +7 more
wiley +1 more source
Voltage stability assessment and improvement of Ethiopian 230 kv wind-integrated grid using SVC and continuation power flow in PSAT. [PDF]
Yenealem MG.
europepmc +1 more source
A cross‐layer passivation strategy employing molecularly designed thiazol‐5‐ylmethanamine hydrochloride (TMACl) enables coherent defect regulation at the SnO2/perovskite interface, stabilizes both layers, promotes phase‐pure α‐FAPbI3 formation, and enhances charge extraction, delivering PCEs of 26.44% in rigid and 24.72% in flexible perovskite solar ...
Fan Shen +16 more
wiley +1 more source
GRU controller-based UPQC compensator design for improving power quality in grid-integrated non-linear load system. [PDF]
Goud BS +9 more
europepmc +1 more source
Unlocking Photodetection Mode Switching from a Simple Lateral Design
A simple lateral 2D perovskite photodetector capable of switching among transient, continuous, and dual transient/continuous photoresponse modes is achieved by integrating photoconductive effects with capacitive coupling from the SiO2/Si substrate. Such light‐programmable photodetection mode switching enables triple‐channel information transmission and
Zijun (June) Yong +10 more
wiley +1 more source

