Results 131 to 140 of about 823,974 (286)
Mg2+ confined within poly(heptazine imide) acts as a heterogenized interfacial charge bridge capable to couple synergistically the semiconductor with Pt co‐catalysts, thus enhancing hydrogen evolution. Through water polarization and hydroxide stabilization, a dynamic Mg2+‐OHδ−‐Hδ+‐Pt motif facilitates proton transfer and overcomes interfacial electron ...
Gabriel A. A. Diab +17 more
wiley +1 more source
Youngstown Sheet and Tube Company's Campbell Works boiler house
Refined waste gas is routed to the boiler house to be utilized as fuel to heat water for production of steam. After the boilers were installed, the building was constructed around them.
Youngstown Sheet and Tube Company
core
Abstract Forensic entomology, and potentially microbiology in the future, can be used during death investigations to corroborate an estimated time since death. Instances where products are introduced to a cadaver, either in attempt to conceal or by accident, can affect decomposition and succession of associated decomposer taxa (i.e., insects and ...
Kelly A. Waters +7 more
wiley +1 more source
Abstract Understanding plant behaviour requires the integration of multiple phenotypic and physiological signals measured over time under controlled conditions. However, different plant signals are typically studied using separate experimental setups, limiting temporal alignment and integrative analyses.
Valentina Simonetti +9 more
wiley +1 more source
Delipidisation of wool fibres and the subsequent beneficial properties of delipidised wool fibres
Abstract Wool fibres are complex matrices of proteins and fatty acids/lipids found both internally and externally. 18‐methyleicosanoic acid (18‐MEA) is covalently bound to the surface of the fibre via a thio‐ester link, and is considered one of the most important lipids as it is responsible for the hydrophobic properties of wool fibres.
Jamie A. Hawkes, David M. Lewis
wiley +1 more source
ABSTRACT Background/Aim To evaluate the efficacy of the combined cone‐beam (CBCT)/3D‐replicas protocol on the clinical and radiographic outcomes of autotransplanted molars. Material and Methods Controlled clinical trial registered ISRCTN13563091 from August 2019 to September 2022.
Miks Lejnieks +4 more
wiley +1 more source
Ultra‐High‐Speed Sintering of 3.5Y‐TZP Zirconia: Time Reduction Without Compromising Translucency
ABSTRACT Objectives To assess, firstly, the impact of three sintering speeds on translucency and grain size of 3.5Y‐TZP zirconia (Katana HT) across clinically relevant thicknesses, and secondly, the effect of thermocycling on translucency. Materials and Methods Disc specimens were fabricated at six thicknesses (0.7–2.0 mm) and sintered using SLOW (7 h),
Tatiana Roman +5 more
wiley +1 more source
Comparison of PWR steam generator models
Tässä kirjallisuustyössä tutustutaan kolmeen kaupallisissa painevesilaitoksissa käytettyyn höyrystinkonstruktioon: U-putkipystyhöyrystimeen, U-putkivaakahöyrystimeen ja läpivirtaushöyrystimeen.
Havuaho, Jari
core +1 more source
This artifact is a Tube Curve Generator Model 2. Milton L. Kuder of the National Bureau of Standards (NBS) developed the Electron Tube Curve Generator around 1950 to provide instantaneous visual display of electron tube characeristics.
core
Abstract Three novel taxa in the Coleofasciculales were observed in hot springs in Yellowstone National Park, Wyoming, United States, and in the Tabaconcito thermal springs on the Rio Tabacón in Costa Rica. Flavicapitulum vaporiphilum gen. et sp. nov. was located in a supported clade with Gracilinea and Marmoreocelis.
Jeffrey R. Johansen +3 more
wiley +1 more source

