Results 111 to 120 of about 16,018 (218)
, 2017 The aim of this Master’s thesis is to design a steam condensing turbine with three bleeds. First, a heat balance of the steam cycle is calculated, followed by thermodynamic and stress calculation of the turbine blading and design of a gland steam system ...
Štěpánová, Lenka
core
Coupling a biomass gasifier with a solid oxide fuel cell system through a high-temperature syngas compressor holds great promise to achieve low-emission, small-scale combined heat and power, since it reduces the number of heat exchangers and increases ...
Schiffmann, Jürg +2 more
core +1 more source
Dataset on thermodynamics performance analysis and optimization of a reheat - regenerative steam turbine power plant with feed water heaters. [PDF]
Data Brief, 2020 Oyedepo SO +10 more
europepmc +1 more source
, 2016 Bachelor thesis deals with design of back-pressure sngle-stage steam turbine. This turbine is designed to process technologic steam in chemical factory.
Susna, David
core +1 more source
, 2008 Steam turbines are widely used in most industrial facilities because steam is readily available and steam turbine is easy to operate and maintain. If designed properly, a steam turbine co-generation (producing heat and power simultaneously) system can ...
Quach, K., Robb, A. G.
core
A non-linear weighted least squares gas turbine diagnostic approach and multi-fuel performance simulation [PDF]
, 2011 The gas turbine which has found numerous applications in Air, Land and Sea applications, as a propulsion system, electricity generator and prime mover, is subject to deterioration of its individual components.
Kamunge, Daniel
core
, 2013 Damage tolerant life assessment and the resulting component repair and replacement scheduling is crucial to the continued operation of UK power plant.
Soady, K.A.
core
, 2013 This thesis deals with brush steam turbine operation. This turbine is installed in small biomass incineration plant, which is situated in premises of company Dřevopar s.r.o. in Loštice. First part is focused on incineration plant technology introduction.
Rosypal, Štěpán
core
Gland steam system for a steam turbine
, 2017 The diploma thesis deals with preliminary design of condensing steam turbine with three unregulated steam outputs and its gland steam system particularly its description and design. The steam parameters in key outputs were determined in heat balance. The
Skala, Šimon
core +1 more source
The Design and Development of An Externally Fired Steam Injected Gas Turbine for Cogeneration
, 1981 This paper describes the theoretical background and the design and development of a prototype externally fired steam injected (ECSI) gas turbine which has a potential to utilize lower grade fuels.
Boyce, M. P., Meher-Homji, C., Ford, D.
core