Results 51 to 60 of about 591,674 (287)
MATEC Web of Conferences, 2017 Calculations to determine optimum value of steam reheat temperature in relation to the cycle arrangement of steam turbine power plant with gas turbine topping are conducted in this paper.
Romashova Olga +4 more
doaj +1 more source
A Consideration on the Flow of Steam in Steam Turbines.
Journal of the Society of Mechanical Engineers, 1941 多段落衝動タービンの相隣れる段落に於て、前段落の羽根より流出する蒸汽の有する速度エネルギの利用問題を中心として、タービン内における蒸汽の流動を取扱つた。就中低圧部で相隣れる二つの段落の間隙が可なりあり、且両段落の平均羽根円直径に急変を與へる場合をとつて、かゝる構造の汽室内に運轉状態の如何によつて起ることあるべき蒸汽の種々の流動状態を近似的計算によつて解析した。そして如何なる設計にすればかゝる特殊構造の段落のノズル效率を増進し、且その特性を改善し得るかを論じた。
openaire +2 more sources
Ocean Wave Energy Generators and Self‐Powered Wave Sensors Based on Triboelectric Nanogenerators
Advanced Energy and Sustainability Research, EarlyView.The key milestones of ocean wave energy‐driven triboelectric nanogenerators (TENGs) from 2015 to 2024. The development of ocean wave energy‐driven TENGs has undergone multiple stages of evolution, particularly in the design of their outer structures, with the goal of more efficiently utilizing ocean wave motion.
Yunzhong Wang, Youhong Tang
wiley +1 more source
Steam turbine stress control using NARX neural network
Open Engineering, 2015 Considered here is concept of steam turbine stress control, which is based on Nonlinear AutoRegressive neural networks with eXogenous inputs. Using NARX neural networks,whichwere trained based on experimentally validated FE model allows to control ...
Dominiczak Krzysztof +2 more
doaj +1 more source
EXERGY ANALYSIS OF THE MAIN PROPULSION STEAM TURBINE FROM MARINE PROPULSION PLANT
Brodogradnja, 2019 The paper presents exergy analysis of main propulsion steam turbine from LNG carrier steam propulsion plant. Measurement data required for turbine exergy analysis were obtained during the LNG carrier exploitation at three different turbine loads. Turbine
V. Mrzljak, I. Poljak, J. Prpić-Oršić
semanticscholar +1 more source
STEAM TURBINE HEAT RATE ANALYSIS BY METHOD PERFORMANCE TESTS ON POWER PLANT IN PT. KSA PALM FACTORY
Rekayasa MesinThis research analyzed the heat rate of a steam turbine in the palm factory of PT. KSA (PT. KSA) using performance testing methods. Steam turbine heat rate is a crucial parameter in power plant efficiency, and optimizing it can lead to significant cost ...
Alfan Khusnaini +3 more
doaj +1 more source
发电技术, 2019 The bearing vibration of No.2, No.3, No.4, No.5, No.6 of a 600 MW supercritical steam turbine in a power plant is relatively large. In order to solve this problem, the intake mode of the steam turbine was changed by prolonging the operation time of the ...
Xiaojun HUANG, Xiangguo DU
doaj +1 more source
Asia-Pacific Journal of Chemical Engineering, EarlyView.ABSTRACT To alleviate the impact of the instability of renewable energy power generation on the power grid, coal‐fired power plants (CFPPs) have to undertake peak shaving tasks, which puts forward high requirements for the flexibility of CFPPs. To enhance the flexibility of CFPPs to consume more renewable energy, this paper innovatively proposes a ...
Yuguo Ni, Keliang Liu, Miao Yu, Hao Zhou
wiley +1 more source
Rekayasa MesinSteam turbines are widely used at many industrial. The purpose of this research was to study the effect of load capacity on steam flow mass rate. Load Capacity is directly proportional to the steam flow mass rate to increase Steam turbine power.
Teddy Tratama +3 more
doaj +1 more source
Case Studies in Thermal Engineering, 2023 The secondary water droplets in the steam turbine wet steam stage are easy to cause water erosion damage to the rotor cascade, and there is a large speed slip between the main steam flow and the secondary water droplets, which will seriously affect the ...
Xu Han +6 more
doaj +1 more source