Results 141 to 150 of about 991,242 (315)

Joseph Steel (Father) Notices of Sale of stock and implements at Clipping Norton

open access: yes, 2016
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Steel Family
core  

Rolling work and power in high-speed finishing blocks of wire mills

open access: yesЛитьë и металлургия, 2001
It is shown that with real drawing-down coefficients used in stand finishing blocks at hot rolling of steel wire rod the rolling speeds when metal can break in strand exit plane are impossible to reach in practice.
V. V. Fillippov   +4 more
doaj  

Early Clinical, Imaging, and Pathological Characteristics of SRPK3/TTN‐Digenic Myopathy

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective SRPK3/TTN‐digenic myopathy was recently established as a skeletal muscle myopathy caused by digenic inheritance. This study characterizes the early clinical presentation of SRPK3/TTN‐digenic myopathy in one previously reported and seven newly identified pediatric patients.
Rotem Orbach   +23 more
wiley   +1 more source

Influence of distribution of metal density within width of roller transporter on uniformity of rolled wire laps chilling

open access: yesЛитьë и металлургия, 2002
There is analysed the influence of distribution of metal density within width of transporter on uniformity of rolled wire chilling. The ways of increasing of uniformity of structure and characteristics of rolled wire by length of hanks are offered.
S. M. Zhuchkov   +4 more
doaj  

Remarkable Recovery After Delayed High‐Dose Methylprednisolone in a Rare Case of Penetrating Spinal Cord Injury

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Traumatic spinal cord injury (TSCI) caused by sharp‐force penetration is exceptionally rare, and the use of high‐dose methylprednisolone (MP) remains highly controversial, especially beyond the conventional 8‐h treatment window. This case report describes a 30‐year‐old male with acute incomplete TSCI following a knife stab wound to the right ...
Honghong Wang   +5 more
wiley   +1 more source

A feasibility study on mechanical connections of very high strength (VHS) circular steel tubes

open access: yes, 2011
The Very High Strength (VHS) circular steel tube is a quenched and tempered high alloy steel that was invented in Australia in the 1990s. It has a yield strength of 1350MPa that is three times higher than the strength of common structural steels being ...
Xiao, Zhigang   +3 more
core  

INFLUENCE OF THE RINGS FORMING TEMPERATURE ON STRUCTURE AND CHARACTERISTICS OF ROLLED WIRE AT HIGH-SPEED ROLLING

open access: yesЛитьë и металлургия, 2007
It is shown that decrease of stacking density of rolled wire coils on the conveyer of roller “Stelmor” due to increase of speed of the roller sections at the 1” stage of cooling till the maximum value results in stability of the strength characteristics.
V. A. Matochkin   +4 more
doaj  

Risk of Non‐Arteritic Anterior Ischemic Optic Neuropathy in Idiopathic Intracranial Hypertension Patients Treated with GLP‐1 Receptor Agonists

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Introduction Glucagon‐like peptide‐1 receptor agonists (GLP‐1 RAs) have demonstrated significant weight‐reducing effects and may offer benefits in idiopathic intracranial hypertension (IIH); however, recent concerns about the risk of non‐arteritic anterior ischemic optic neuropathy (NAION) have emerged.
Faisal A. Al‐Harbi   +9 more
wiley   +1 more source

Concrete-filled VHS-to-mild steel plate fabricated section stub column tests

open access: yes, 2011
Six stub columns fabricated using very high strength (VHS) tube and mild steel facet plates were concrete filled and tested under axial compression. Load-deformation curves were used to determine the maximum axial compressive strength of the specimens ...
Uy, Brian (R9735)   +2 more
core  

IMPROVEMENT OF THERMOSTRENGTHENING MODE OF VALVE № 14, 16 CLASS 500 IN SMALL SECTION MILL 320 OF «BSW

open access: yesЛитьë и металлургия, 2012
Advanced mode of valves № 14, 16 500 class thermostrengthening, allowed to increase the productivity of the mill 320 without degradation of mechanical properties, reduce the energy used to produce steel.
М. A. Murikov   +3 more
doaj  

Home - About - Disclaimer - Privacy