Results 211 to 220 of about 2,087,703 (285)
Properties of FRC with Carbon Fibres from Recycled Wind Turbine Blades. [PDF]
Szmatuła F, Korentz J.
europepmc +1 more source
ABSTRACT While cross‐laminated timber (CLT) is increasingly utilized in lateral force‐resisting systems in mass timber construction, research has predominantly focused on platform‐type construction. Balloon‐type CLT shear wall systems offer distinct structural advantages, notably the elimination of cumulative perpendicular‐to‐grain compression and a ...
Samira Mohammadyzadeh +3 more
wiley +1 more source
Data-driven modeling for bond strength in reinforced concrete structures. [PDF]
Singh P +5 more
europepmc +1 more source
ABSTRACT Conventional single intensity measure (IM) fragility approaches with simplified component dependency assumptions overlook the progressive damage accumulation and evolving inter‐component correlations that govern system behavior under mainshock‐aftershock (MSAS) loading.
Muhammad Rashid, Mayuko Nishio
wiley +1 more source
Mechanical and Microstructural Performance of Concrete Incorporating Waste Tire Rubber and Recycled Steel Fibers Under Elevated Temperatures. [PDF]
Ayhan E, Değer MK, Doğruyol M.
europepmc +1 more source
ABSTRACT Seismic fragility assessment of reinforced concrete (RC) bridges exposed to corrosive environments must reliably capture time‐dependent deterioration impacts. Climate change compounds this challenge through nonstationary temperature and humidity variations that accelerate bridge corrosion.
Yexiang Yan, Yazhou Xie
wiley +1 more source
Effects of fly ash and recycled polyethylene terephthalate fibers on gas emission reduction and indoor environmental quality in concrete structures: a sustainable material approach. [PDF]
Detho A +5 more
europepmc +1 more source
Schematic illustration of the experimental procedure of the specimens. ABSTRACT This research work investigated the effect of the cyclic thermo‐hygrometric aging regime between −20°C and +40°C with 0–400 cycles on the reciprocating tribological properties of fused deposition modeling (FDM) printed polylactic acid (PLA) and the same material reinforced ...
Sinan Fidan +5 more
wiley +1 more source
Sustainable materials selection with emerging structural materials. [PDF]
Burdett S, Arora M, Myers RJ.
europepmc +1 more source

