Results 141 to 150 of about 5,336 (243)

Comparative structural, thermal, and fatigue analysis of connecting rod materials for ural-4320 military diesel engines using finite element method. [PDF]

Sci Rep
Wakshume E, Sufe G.
europepmc   +1 more source

Analysis on hydraulic dynamic stiffness characteristics and experimental research of asymmetric valve-controlled asymmetric cylinder system. [PDF]

Sci Rep
Weiwei L, He Yong H, Chuiyi L.
europepmc   +1 more source

Comparative Study of Wear Behavior of Hypereutectic Al-Si Piston Alloys Using Experimental and Numerical Methods. [PDF]

Materials (Basel)
Tashev A, Nikolov V, Dochev B, Dimova D, Kandeva M, Zagorski M.   +5 more
europepmc   +1 more source

Unveiling earthquakes: thermoluminescence signal resetting of a natural polymineral sample in laboratory-produced fault gouge. [PDF]

Sci Rep
Heydari M, Kreutzer S, Hung CC, Ghassemi MR, Martin L, Tsukamoto S, Preusser F, Niemeijer A.   +7 more
europepmc   +1 more source

Sustainable design and durability of domestic micro combined heat and power scroll expander systems.

Research to understand the mechanisms of wear within the main components of three different micro-CHP scroll expander systems was conducted. This was performed in order to identify the possible tribo-mechanical effects (abrasion, adhesion, cavitation ...
Tzanakis, Iakovos
core  

Optimization of the Spatial Position of the Vibration Acceleration Sensor and the Method of Determining Limit Values in the Diagnostics of Combustion Engine Injection System. [PDF]

Sensors (Basel)
Monieta J, Kasyk LW.
europepmc   +1 more source

Failure analysis and structural design improvement of support device for heavy-duty rack and pinion hydraulic actuator. [PDF]

Sci Rep
Zhang D, Luan B, Chen F, Zhu X, Xie Y, Wan Y, Ji S, Wang C, Choi JH.   +8 more
europepmc   +1 more source

Optimization Research on the Drilling Parameters of the RC-DTH Air Hammer by Employing Smoothed Particle Hydrodynamics. [PDF]

ACS Omega
Qiao J, Shi L, Yan L, Hou Y, Li X, Wei T, Guo J, Liu Z.   +7 more
europepmc   +1 more source

Bulk forming technology of piston of disk brake

, 2008
The project of Master’s thesis elaborated within engineering studies of branch 23-03-T002 proposes a technology of production of disk brake piston made of low-carbon steel EN C10E. Supposed production amount is 300 000 pieces per year.
Toman, Svatopluk
core  

Effect of gas flow rate on the gas-lubricated piston in a stirling cryocooler. [PDF]

Sci Rep
Lei D, Zhang A, Gong X, Yu W, Xiong C, Chen H.   +5 more
europepmc   +1 more source