Results 31 to 40 of about 161,530 (168)
A New Bursting Liability Evaluation Index for Coal –The Effective Elastic Strain Energy Release Rate
Energies, 2019 Because both faults and cleats exist in coal, sharp stress drops occur during loading when coal is deformed. These drops occur during the pre-peak stage and are accompanied by sudden energy releases.
Zhiguo LU +6 more
doaj +1 more source
Fracture and Structural Integrity, 2021 The use of composite materials is on the rise in different engineering fields. The main advantage of these materials for the aerospace industry being their low weight for excellent mechanical qualities. The analysis of failure modes, such as delamination,
Mohamed Ben Ali Amina, Bouziane Salah
doaj +1 more source
Propagation of Matrix Cracking and Induced Delaminatin in Cross-Ply Composite Beams Subjected to Bending Loads [PDF]
Mechanics of Advanced Composite Structures, 2019 Due to the mismatch of mechanical properties in composite laminates, propagation of delami-nation is considered as a severe damage mechanism in beams with various lay-up configurations.
Mohammad Bahrami, Amin Farrokhabadi
doaj +1 more source
Geomechanics and Geophysics for Geo-Energy and Geo-ResourcesThe weakening of circular tunnels is a global problem that has not been resolved satisfactorily. In the tunnelling process, surrounding rock of circular-tunnel performs a process of “excavating → weakening → continuous excavating → weakening strengthens”.
Xun You +4 more
doaj +1 more source
R-curve Evaluation of Copper and Nickel Single Crystals Using Atomistic Simulations
Crystals, 2018 The technique of molecular statics (MS) simulation was employed to determine the crack growth resistance curve of Cu and Ni single crystals. Copper and Ni single crystal nanoplates with an edge crack subjected to a tensile displacement were simulated ...
Xiao Ru Zhuo +2 more
doaj +1 more source
The crack kinking out of an interface [PDF]
Theoretical and Applied Mechanics, 2005 Kinking of a plane strain crack out of an interface between the two dissimilar isotropic elastic materials is analyzed. Analysis is focused on the initiation of kinking and thus the segment of the crack leaving the interface is imagined to be short ...
Veljković Jelena M.
doaj +1 more source
Mixed-mode I/III fracture study of sandwich beams
Cogent Engineering, 2015 The capacity of prestressed split-cantilever beam (SCB) for investigation of mixed-mode I/III fracture in foam core sandwich constructions was evaluated theoretically. The fracture was studied in terms of the strain energy release rate. In this relation,
V. Rizov
doaj +1 more source
Fracture toughness and critical strain energy release rate of dental amalgam [PDF]
Journal of Materials Science, 1978 Fracture toughness, critical strain energy release rate and critical stress intensity factor were determined for lathe-cut, spherical, admixed, and two atomized high-copper dental amalgams. At a loading rate of 0.005cm min−1 for 24-hour samples, the spherical amalgam had the highest resistance to unstable crack propagation.
Powers, John M. +2 more
openaire +2 more sources
Earthquake volume, fault plane area, seismic energy, strain, deformation and related quantities
Annals of Geophysics, 1964 An effort is made to improve Benioff's method for investigation<br />of strain release in aftershock sequences. The improvement<br />may be summarized as follows:<br />1.
S. J. DUDA, M. BATH
doaj +1 more source
Геодинамика и тектонофизика, 2020 According to the steady state of fault and energy balance, we provided a new idea to observe the precursors for a stressed fault. The meta-instability (or sub-instability) state of a fault is defined as the transition phase from peak stress to critical ...
Yanshuang Guo +4 more
doaj +1 more source