Results 91 to 100 of about 916,884 (347)
Advanced Engineering Materials, EarlyView.The release of foulers from protective marine coatings is determined by several interrelated material properties, including the strength of Young's modulus, the flexibility of chain segments, the surface free energy, and the magnitude of hydrodynamic stress.
Johann C. Schaal +2 more
wiley +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Stress Analysis of the Contact Deformation of Gear Shaving
Jixie chuandong, 2017 The elastic plastic deformation of the tooth contact deformation area is an important factor which influences the concave error of shaving teeth.
Cai Anjiang +3 more
doaj
, 2015 During the machining of aerospace thin-walled components, a large amount material is removed, and machining-induced residual stress is induced in the boundary layer of the work piece, which results in deformation of the components.
Xiaoming Huang, Jie Sun, Jianfeng Li
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Effect of pre-hoop expansion deformation on the tensile and fatigue properties of zirconium plate
Journal of Materials Research and TechnologyThe effect of the pre-hoop expansion deformation on the tensile and fatigue properties of zirconium plate has been investigated. The results showed that with the increase of the pre-hoop expansion deformation, the yield and ultimate strength increased ...
Haidong Qi, Xiping Song
doaj +1 more source
Advanced Engineering Materials, EarlyView.The low cycle fatigue life of additive manufactured HAYNES® 282® superalloy was investigated for conventional and high‐productivity processing: samples of the former lasted 1400–1700 cycles, while samples of the latter failed at ~ 1200 cycles, at 760 °C and 1% strain.
Abdul Shaafi Shaikh +3 more
wiley +1 more source
Flow behavior at different shear rates for dry powders [PDF]
, 2010 Using Discrete Element Simulations (DEM), an effort is made to study the so called “Split bottom ring shear cell” where a slow, quasi-static deformation leads to wide shear bands.
Luding, S., Singh, A.
core +1 more source
Dislocation interactions mediated by grain boundaries
, 2008 The dynamics of dislocation assemblies in deforming crystals indicate the emergence of collective phenomena, intermittent fluctuations and strain avalanches.
Fetter A L +10 more
core +1 more source
Advanced Engineering Materials, EarlyView.This article demonstrates the successful qualification of a copper–tungsten composite for laser powder bed fusion. The resulting components exhibited high density, high thermal conductivity, and reduced thermal expansion. Heat sinks with complex geometries were successfully manufactured, clearly showcasing the material's potential for additive ...
Simon Rauh +6 more
wiley +1 more source