Results 11 to 20 of about 4,023 (169)
This work proposes a methodology for defective pipe elastoplastic analysis using the Euler Bernoulli beam-pipe element formulation. The virtual work equation is modified to incorporate the stress concentration factor in beam-pipe element formulation. The
Hsu Yang Shang
doaj +1 more source
In order to study the influence of the three-dimensional appearance of the gear pitting pits on the stress concentration of the tooth surface, the effect of pitting pits with different shapes on stress concentration factor of gear was analyzed by finite ...
LI YouHua +5 more
doaj
Stress Concentration Factor of Expanded Aluminum Tubes Using Finite Element Modeling
This paper discusses the development of semi-empirical relations for the maximum stress concentration factor (SCF) around circular holes embedded in aluminum tubes under various expansion ratios and mandrel angles. Finite element models were developed to
L Mhamdi +4 more
doaj +1 more source
The influence of pit shape and size on local stress concentration in the tensile specimen and the stress corrosion cracks inception was studied by employing the element remove technique.
Longhao Xiang, Juyi Pan, Songying Chen
doaj +1 more source
Research on Fatigue Properties of Typical Welded Joints of DH36 Steel at −60 °C
As the development of the polar region continues to increase, the fatigue properties of structures at low temperature are increasingly receiving researcher attention. This study aimed to investigate the fatigue properties of T-welded and cruciform welded
Weidong Zhao +3 more
doaj +1 more source
Investigation of Double Notch Influence on Crack Propagation in S355 Steel: Experimental and Numerical Study [PDF]
This paper presents a study aimed at establishing a numerical finite element model of the tensile behavior of an S355 steel under the effect of double notching using CAST3M software.
Hachim Abdelilah +7 more
doaj +1 more source
Using Topology Optimization to Reduce Stress Concentration Factor in a Plate with a Hole [PDF]
This paper focuses on reducing stress concentration in a plate with a hole. For this purpose, a novel Reliever Topological Material Elimination (RTME) approach was introduced which uses the topology optimization technique to specify the best areas to ...
S. Karimi, J. Jafari Fesharaki
doaj +1 more source
Behaviour of vertical cylindrical tank with local wall imperfections
Design of modern thin-walled metal structures is widely used around the world. In recent decades, more comprehensive research is carried out to investigate the behaviour of various thin-walled structures. Generally, the structure with regular geometry is
Antanas Šapalas +4 more
doaj +1 more source
The results of the parametric analysis of the cylinder-cylinder intersections in pressure vessels, performed in both elastic and plastic regions, are discussed in this study. Besides, the outcomes that contribute to the development of classical solutions
Murat Bozkurt, David Nash
doaj +1 more source
Printed circuit heat exchangers (PCHEs) are often subject to high pressure and temperature difference between the hot and cold channels which may cause a mechanical integrity problem.
Armanto P. Simanjuntak, Jae-Young Lee
doaj +1 more source

